Page 2 - Getting Started
2 • Insert the AirNavigator CD into the CD-ROM drive of your computer. The AirNavigator Setup Wizard should launch automatically. • To launch the AirNavigator Setup Wizard manually, click Start , then Run . Type “ D:\ Setup.exe ”, where D is the drive letter assigned to your CDrom. • Click OK to lau...
Page 3 - Installing Wireless Drivers
• Select Install Wireless Drivers . Installing Wireless Drivers
Page 5 - Power off the desktop PC. Insert the; Wireless PCI Adapter; into an available PCI slot. PCI slots; Found New Hardware Wizard; will launch automatically. If the Found New Hardware Wizard; Install the software automatically
5 • Power off the desktop PC. Insert the Wireless PCI Adapter into an available PCI slot. PCI slots are located inside the desktop computer. Please consult the PC Manufacturer's documentation for PCI installation instructions. Once the Wireless PCI Adapter is installed correctly, attach the included...
Page 6 - Installing Drivers
• When the ‘Found New Hardware Wizard’ launches, click Next . • If the ‘Digital Signature Not Found’ page opens, click Yes . • When the Wireless PCI Adapter is successfully installed, click Finish . Restart your computer if prompted. Installing Drivers
Page 7 - Connecting Wireless Clients to your Network
Connecting Wireless Clients to your Network Buffalo supports three different methods for connecting your wireless client device to your network.If your AP supports it, use the simple, utterly secure AOSS to connect. Install the Client Manager from your AirNavigator CD (page 8) and turn to page 11.Yo...
Page 8 - automatically disabled.; Installing Client Manager; Start; Client Manager
Client Manager can be used to survey and connect to available access points, configure WPA/WEP encryption, and create connection profiles. Note: When Client Manager is installed, Windows XP Wireless Zero Configuration is automatically disabled. Installing Client Manager Insert the AirNavigator CD in...
Page 9 - Once the Client Manager Installer launches, click
Client Manager • Once the Client Manager Installer launches, click Next . • Press Agree to accept the license agreement and continue installation.
Page 10 - OK
10 Client Manager • Click OK when Client Manager installation is complete. • Press Exit Setup to exit AirNavigator. • Client Manager is now installed and running. Right-click on its icon (the black antenna) to use it.
Page 11 - Using AOSS
11 The AOSS button for this wireless client is in its Client Manager software. Start Client Manager by right clicking on the black antenna icon in your System Tray, or by launching the Client Manager from your Start Menu: Programs >> Buffalo >>AirStation Utility >> Client Manager. ...
Page 14 - Status Page; Status; Adapter Name; Client Manager Configuration
14 You may use Client Manager to configure your wireless network. Client Manager consists of the Status page, the Survey page, and the Profiles page. You can access each page by clicking the corresponding button on Client Manager. In addition to these pages, several dialog boxes are also available. ...
Page 15 - Displays whether network is in Ad-Hoc or Infrastructure mode.
15 Client Manager Configuration • Network Type - Displays whether network is in Ad-Hoc or Infrastructure mode. • Rate – The speed of communication between wireless devices. If the Client Manager is not connected to a remote wireless device (access point or another client), no rate will be displayed....
Page 16 - Scan; Wireless SSID; Connect
1 Click the Scan tab to open this page. Here, you can survey the area, display available access points, and connect to available access points.This page includes the following components: • Wireless SSID – The SSID is the “name” of a wireless network. Each wireless device on a network must use ident...
Page 18 - Profiles Page; Profiles; Edit; Add
1 Profiles Page Click the Profiles tab to open this page. Use this page to access your profiles. Profiles allow you to save the information associated with a specific wireless network so you can quickly and easily connect to that network when you are in that location. The Profiles page allows you to...
Page 19 - New Profile Dialog Box; – Select whether the profile is for a wireless or
1 New Profile Dialog Box • Select Profile – Select whether the profile is for a wireless or wired connection. • Profile Name – Enter the name you want to associate with the new profile. • Network Type – Select the network mode you want to associate with the new profile. Select Infrastructure if your...
Page 20 - Advanced Profile Options; Network Tab; specified by an administrator.; Browser Tab; can specific proxy server addresses.; Printers Tab; – Click the; AOSS Icon; – To automatically add the USB wireless client to your network,
20 Advanced Profile Options • Network Tab – Displays the network information tab. A static IP can be specified for this wireless profile here. It is not recommended to change any of these settings unless specified by an administrator. • Browser Tab – Displays settings to change your browser preferen...
Page 21 - Zero Configuration Service
21 Windows XP includes the Zero Configuration Service, a built in serrvice to configure your wireless clients from within Windows. Turn to page 7 if you would rather use Buffalo’s Client Manager to configure your wireless client. • If the Wireless Zero Configuration Service is activated, Windows wil...
Page 24 - Installation with Windows /Me; After powering off the PC, insert the
24 Installation with Windows /Me • After powering off the PC, insert the Wireless PCI Adapter into an available PCI slot. PCI slots are located inside the desktop computer. Please consult the PC Manufacturer's documentation for PCI installation instructions. Once the Wireless PCI Adapter is installe...
Page 27 - Antenna Information
2 Antenna Information • The WLI2-PCI-G54S comes with a detachable omni directional antenna. However, for increased range a more powerful antenna can be purchased. Use the included antenna adapter (small brass piece) to connect it to an optional Buffalo MC Connector antenna.
Page 28 - Wireless Zero Configuration; Wireless Zero Configuration Service (Windows XP); Enabling the Wireless Zero Configuration Service; Start»Control Panel»Administrative Tools»Services; Automatic; Disabling the Wireless Zero Configuration Service; Select; to open the Services window. Select; Disabled; Zero Configuration Service.
2 Wireless Zero Configuration Wireless Zero Configuration Service (Windows XP) Windows XP offers the Wireless Zero Configuration Service to support 802.11b and 802.11g wire - less networking. This service automatically polls the area for available wireless access points. If an available wireless acc...
Page 29 - Specifications; Wireless LAN Interface; Communication Protocol; Others; Interface
2 Specifications Wireless LAN Interface Standards Compliance IEEE 802.11g Communication Protocol Direct Sequence Spread Spectrum (DS-SS), Half Duplex Frequency Range 2.412-2.462Mhz Transmission Rates 802.11g: 1, 2, 5.5, 11, 18, 24, 36, 48, 54 125* Mode: 13, 20, 27, 40, 54, 80, 110, 125 Access Mode I...
Page 30 - Communication Range; Speed
0 Specifications Communication Range Speed Indoor Outdoor 54Mbps 165 ft. (50m) 525 ft. (160m) 11Mbps 300 ft. (90m) 1310 ft. (400m) 1Mbps 375 ft. (115m) 1750 ft. (550m) All distances are estimated. Wireless connections may be affected as physical conditions and circumstances vary.
Page 31 - Troubleshooting / FAQ; Use this section to locate answers to frequently asked questions.; Will Client Manager support all operating systems?
1 Troubleshooting / FAQ Troubleshooting / FAQ Use this section to locate answers to frequently asked questions. What should I do if I already have a version of Client Manager on my PC? Update your Client Manager to the version on the CD. If you do not update your Client Manager, there could be a los...
Page 32 - Where can I attach my external antenna?; Windows XP; abled; Configuration Service.; I have more than one Air Navigator CD. Do I need more than one CD?; less adapter. The CDs are identical and you only need one copy.
2 Troubleshooting / FAQ Where can I attach my external antenna? Insert your external antenna into the antenna connector, located on the back of the G54 Wireless PCI Adapter. Why won't Client Manager function properly? Windows XP – The Wireless Zero Configuration Service conflicts with Client Manager...
Page 33 - DHCP (Dynamic Host Configuration Pro; Glossary
10BaseT or 100BaseTx: 802.3 based Ether - net network that uses UTP (Unshielded twisted pair) cable and a star topology. 10 is 10 Mbps and 100 is 100 Mbps. 802.1x: The standard for wireless LAN authenti- cation used between an AP and a client. 802.1x with EAP will initiate key handling. Ad-Hoc Netwo...
Page 34 - Destination Address:; a packet that identifies the intended recipient
4 Driver: Software that interfaces a computer with a specific hardware device. DSSS (Direct Sequence Spread Spectrum): Method of spreading a wireless signal into wide frequency bandwidth. DTE (Data Terminal Equipment): Device that con10BaseT or 100BaseTx: 802.3 based Ethernet network that uses UTP (...
Page 35 - File and Print Sharing:; A fixed block of data, transmitted as a
5 nected to it, and retrieves the address when the device becomes dormant for a period of time. DNS (Domain Name System): System used to map readable machine names into IP ad- dresses Driver: Software that interfaces a computer with a specific hardware device. DSSS (Direct Sequence Spread Spectrum):...
Page 36 - IEEE (Institute of Electrical and Electronics; binary-digit number that identifies each sender
LED (Light Emitting Diode): The lights on a hardware device representing the activity through the ports. MAC (Medium Access Control) Address: A unique number that distinguishes network cards. Mbps (Mega Bits Per Second): A measure- ment of millions of bits per second. MDI/X (Media Dependent Interfac...
Page 37 - PCMCIA (Personal Computer Memory Card; requires manual configuration.; RADIUS (Remote Authentication Dial In User
NAT (Network Address Translation): An inter- net standard that enables a LAN to use one set of IP addresses for internal traffic and a second set for external traffic. NIC (Network Interface Card): An expansion card connected to a computer so the computer can be connected to a network. Packet: A blo...
Page 40 - Federal Communication Commission Interference Statement; • Consult the dealer or an experienced radio/TV technician for help.
40 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential i...
Page 41 - FCC RF Radiation Exposure Statement:; centimeters between the radiator and your body.; R&TTE Compliance Statement
41 IMPORTANT NOTE: FCC RF Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. This transmit...
Page 43 - Warranty Information; duration to the above period.
4 Warranty Information Buffalo Technology (USA), Inc. products comes with a two-year limited warranty from the date of pur- chase. Buffalo Technology (USA), Inc. warrants to the original purchaser the product; good operating condition for the warranty period. This warranty does not include non-Buffa...
Page 44 - Contact Information; ADDRESS; Monday through Friday; TECHNICAL SUPPORT
44 Contact Information ADDRESS Buffalo Technology (USA), Inc. 4030 West Braker Lane, Suite 120Austin, TX 78759-5319 GENERAL INQUIRIES Monday through Friday 8:30am-5:30pm CST Direct: 512-794-8533 Toll-free: 800-456-9799 Fax: 512-794-8520 Email: [email protected] TECHNICAL SUPPORT North American T...
Page 45 - Technical Support is available 24 hours a day, 7 days a week
45 Technical Support is available 24 hours a day, 7 days a week (USA / Canada) Toll-Free: 866-752-6210 email: [email protected] ©2004, Buffalo Technology (USA), Inc. 4030 W. Braker Ln. Suite 120 Austin, Texas 78759 Tel: 800-456-9799 Fax: 512-794-8606
