Buffalo Technology HD-HGLAN - Manual
Buffalo Technology HD-HGLAN – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Step 1: Connect your Cables; Press the power button on the front of LinkStation to turn it on.
- Page 3 – Step 2: Check your Connection; If problems persist, contact our 24/7 technical support at
- Page 4 – Step 3: Link Navigator Software
- Page 5 – Step 4: Using the Confi guration Utility
- Page 7 – Step 5: Accessing LinkStation Data from a PC
- Page 8 – Technical Specifi cations
- Page 9 – North America Support; is available 24 hours a day, 7 days a week; Europe Support; Technical Support
Unpacking and Setup
Open the shipping carton of LinkStation and carefully unpack its contents. The
carton should contain the following items:
Main
unit
(LinkStation)
1
LinkStation
Base
Plate
1
Base
Rubber
Feet 4
Ethernet
Cable
1
Power
Cord
1
LinkNavigator Installation CD
1
Quick Setup Guide (this user’s guide)
1
Warranty
card
1
If any items are missing or damaged, please contact the reseller or retailer from
which the product was purchased.
The front face of the LinkStation has a protective plastic fi lm covering for
protection from scratching during assembly and shipping. The fi lm may be
removed by peeling it away from any corner of the front face.
Quick Setup Guide
Gigabit LinkStation
HD-HGLAN Series
www.buffalotech.com
v2.6
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Step 1: Connect your Cables Plug LinkStation’s power cord into the back of LinkStation. Plug the other end of the power code into a power outlet. Then, plug the included Ethernet Cable into the Ethernet port on the back of LinkStation. Connect the other end of the Ethernet Cable into a hub, switch...
3 Check the LINK/ACT light on the front of the LinkStation. If it is lit, then LinkStation is connected properly; please turn to Page 4 to continue setup. If it is not lit, continue to the next step. Verify that the LINK/ACT light on the front of LinkStation is lit (see Step 4 ’s picture). If it is ...
4 Insert the LinkNavigator CD into the PC’s CD-ROM drive. Depending on the PC’s confi guration, the EasySetup program may launch. If it does not automatically launch, manually launch it by pressing the ‘ Start ’ menu and selecting the ‘ Run... ’ option. When the ‘Run’ dialog opens, type x:\easysetup...
