Briggs & Stratton 1695353 - Manual

Page 2 - SAVE THESE INSTRUCTIONS; READ THE MANUAL; Hazard Symbols and Meanings; DANGER

SAVE THESE INSTRUCTIONS READ THE MANUAL The operator’s manual contains important safety information you need to be aware of BEFORE youoperate your unit as well as DURING operation. Safe operating techniques, an explanation of the product’s features and controls, and maintenanceinformation is include...

Page 3 - Table of Contents; Normal Removal

Table of Contents Operator Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Operator Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2Safety Decals . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....

Page 4 - Safety; GENERAL WARNINGS; SAFETY DECALS; WARNING

2 Safety • Know the unit’s controls and how to stop quickly. READ THE OPERATOR’S MANUALS. • Read and obey all safety decals.• Only allow responsible adults, who are familiar with the instructions, to operate the unit. • Disengage the PTO. Shut off the engine and wait for all moving parts to stop bef...

Page 5 - After Operation; CAUTION

3 Before Operation Clear the lawn of all sticks, stones, wire and otherdebris which may be caught or thrown by the mowerblades. Check grass condition. If wet, wait until later in theday. If grass is wet, the grass catcher is likely tobecome plugged. For efficient bagging, air circulation under themo...

Page 6 - Notes

Page 7 - Install Plates & Spacers; Assembly

5 INSTALL MOUNTING PLATES -BROADMOOR / 1600 / 2600 / LTSERIES Install Plates & Spacers 1. Mount the side brackets (C, Figure 1) to both sides of the frame using the holes shown. Securewith one 3/8-16 x 1 capscrew (D), 3/8 lockwasher(B), and 3/8-16 nut (A) per side. 2. Install the rear spacers (C...

Page 8 - Install Baffle and Blade

6 Assembly Install Baffle and Blade Note: Units with an anti-blowout baffle do not requirethe Clean Sweep baffle. 1. Remove mower deck. See OPERATOR’S MANUAL. 2. Install notched side of baffle (A, Figure 3) to discharge side of deck securing with 5/16-18 x 2carriage bolt (C) and 5/16-18 locknut (D)....

Page 9 - Install Lower Chute Components

7 Assembly Figure 6. Install Pin and Bracket A. Lower ChuteB. Locknut, 1/4-20C. Puck, MetalD. Capscrews, Thin Head, 5/16-18 x 3/4E. Locknuts, 5/16-18F. BracketG. Defflector Prop A C F G D D E Install Lower Chute Components INSTALL BRACKET AND PIN ON LOWER CHUTE 1. Secure the puck (C, Figure 6) to lo...

Page 14 - Bagger Removal

12 E G D B Figure 14. Normal Installation & Removal C I J K A WARNING OPERATION WITHOUT BAGGER For operation without bagger, the mowerdeflector MUST be properly installed in thedown position and retained by the spring latch. H F D C L Normal Removal & Installation L A. Hitch SupportAssemblyB...

Briggs & Stratton 1695353 - Manual

Table of Contents:

Summary

Other Briggs & Stratton Models