ZLINE Kitchen and Bath ALP70IS-30 - Manuals

33 Gener al Safet y • All ZLINE range hoods are ETL listed, ensuring all parts were tested for safety and meet industry standards and regulations. NOTE: This ensures all included metal ducting pieces were tested for safety and are flame retardant. • Always turn the range hood ON when cooking at high...

4 30”-36” 36” Height 26” - max 3 9” Installation Tutorial Video 4 Island Hood Installation ISLAND HOOD INSTALLATION

5 Please unpack your range hood when it is delivered and inspect to ensure all parts are included.1. Main Hood with All Lights and Button Banks Pre-Installed 2. Chimney3. Transition Piece (for 6” or 8”)4. Baffle Filters 5. Packet of Screws and Anchors6. Top Mounting Bracket7. Grease Cup Screw: F Scr...

66 Island Hood Installation The recommended height to install your hood is 30˝ minimum and 36˝ maximum above the cooktop. For Outdoor (304 Series) hood installation, the unit must be installed at a minimum of 36˝ and a maximum of 42” above the grill. 1. Locate the center above the stove where the ho...

8 30”-36” 36” Height Max 36” Installation Tutorial Video 8 Designer Island Hood Installation DESIGNER ISLAND HOOD INSTALLATION

9 Please unpack your range hood when it is delivered and inspect to ensure all parts are included. 1. Main Hood with All Lights and Button Banks Pre-Installed 2. Chimney3. Transition Piece (for 6” or 8”)4. Baffle Filters 5. Packet of Screws and Anchors6. Crown Molding Bracket7. Crown Molding8. Greas...

10 The recommended height to install your hood is 30˝ minimum and 36˝ maximum above the cooktop. For Outdoor (304 Series) hood installation, the unit must be installed at a minimum of 36˝ and a maximum of 42” above the grill. 1. Locate the center above the stove where the hood is to be installed. En...

11 6. Slide chimney pieces over the angle iron on the hood. Pull the electrical plug to the top of the chimney sections. Figure 4 7. Lift the hood to attach the angle iron to the ceiling bracket. Use screws provided to attach. 8. Make your electrical and ducting connections. Use solid ducting made o...

12 12 Island Cr ownSound ® d Installation ELECTRIC POWER RATING Frequency: 110V/50 HzPower: 10W 1. Attach crown molding bracket to ceiling using hardware provided. Figure 1 2. Attach ducting and electrical connections. Plug the speakers into an outlet behind the chimney. When the connection is succe...

13 13 Island Cr ownSound ® Installation 3. Extend the chimney up to the transformer. Slide the crown molding onto the crown bracket and secure into place. The crown should cover the gap. Ensure that it installs properly and is level. Figure 3 4. Open the phone’s Bluetooth settings and find “ZLINE Au...

14 14 Remote Blower Installation When installing your new remote blower type range hood, if so optioned, use the following instructions. Make certain to connect the electrical cord to the hood and plug the blower motor in to test the unit. 1. Run duct work into the area that you will install the rem...

16 Button functions Button Control Panel Operational Manual ! ! ! Power Power-Off Delay Low Speed Medium 1 Speed Light High SpeedMedium 2 Speed Blower Speed Indicator Power: Turn ON/OFF the range hood and activate power-off delay timer. Light: Turn ON/OFF (Some models will have bright, dim, and OFF ...

17 17 HOW TO CHANGE OUT THE BUTTON PANEL 1. Remove baffle/aluminum filters. 2. Locate back of button panel. 3. Remove screws from each side of the button panel. 4. Disconnect button panel from cord connecting to circuit board. NOTE: Never work on or clean the range hood while power is ON. Always unp...

19 19 Replacing Light Bulbs REPLACING THE LIGHT BULBS IN YOUR RANGE HOOD 1. Remove baffles. 2. Squeeze the old LED light casting out until it falls out of the socket.3. Disconnect the plug wires from the light wire.4. Reconnect the LED plug into the light wire.5. Press light assembly into the socket...

20 20 Changing Baffle Filter s PROFESSIONAL SERIES BAFFLE FILTER CHANGE Covering Models 696, 697, and KECOM. Professional series hoods are equipped with 2 removable dishwasher safe baffle channels that the baffle filters rest in. To install the channels, place inside the hood, right under the front ...

21 21 Changing Baffle Filter s BAFFLE FILTER If your range hood has baffle filters with a knob, to remove the filter from the hood, pull back towards the wall and then tilt the knob side of the baffle filter downward. Release CHANGING PARTS

23 23 REPLACE OR CHANGE CHARCOAL FILTERS: It is recommended to direct vent the hood whenever possible. If your situation does not allow for a direct vent install, carbon filters are available to recirculate the air through your hood. Filter Support Screws 1. Remove the stainless steel or aluminum fi...

24 24 Changing th e Grease Cup HOW TO CLEAN, INSTALL, OR REPLACE THE GREASE CUP: A removable grease cup is provided to catch any excess grease at the bottom of the motor. Remove it every 2 to 3 months, wash it, then re-install it. NOTE: Never work on or clean the range hood while power is ON. Always...

25 25 Changing th e T ransformer REPLACE OR CHANGE TRANSFORMER: 1. Remove the screws from the transformer.2. Remove the two connections to the lights.3. Remove the two wired connections from the circuit board (you must remove the circuit board cover). 4. Install the new connections from your new tra...

26 SINGLE MOTOR ELECTRICAL DIAGRAM ground ground 26 Single Motor Electrical Diagr am CHANGING PARTS

27 DUAL MOTOR ELECTRICAL DIAGRAM ground ground ground 27 Double Motor Electrical Diagr am CHANGING PARTS

28 28 Troublesh ooting Where are ZLINE products manufactured? All ZLINE products are manufactured in ZLINE facilities overseas, including: Germany, Italy, and China. Are ZLINE range hoods considered type 1 or type 2? Type 1 - Range hoods that are used with appliances that produce grease and smoke. A...

29 29 Tr oublesh ooting How loud is the range hood? A sone is measure of loudness, the higher the sone rating, the louder the sound of the hood. The sound of one sone is comparable to that of a quiet refrigerator. Keep in mind that other factors such as the size of the blowers can affect the loudnes...

30 30 Troublesh ooting What type of motor is in the range hoods? Our hoods have a squirrel cage motor. Is the width of my range hoods description, the actual size? No, the actual size of the range hood will be slightly less than the generic description of the range hood. For instance: a 30˝ range ho...

31 31 Tr oublesh ooting My hood is operating, but the air is moving slower than normal. Check the filter for buildup and clean or replace it if needed. If the difficulty still persists, check for obstructions in the ductwork. A common obstruction is buildup in the roof or wall cap, such as: bird nes...

32 32 Troublesh ooting My range hood will not operate. 1. Check that there is power to the range hood. The most common issue is that the circuit breaker is off or the fuse has blown. 2. Make sure the speed has been selected at the range hood controls.3. Turn off the power to the range hood and check...

33 33 Tr oublesh ooting My range hood is not pulling. • Was the unit plugged in and was the fan checked before installation?• What distance is the hood mounted above the cook top? • Indoor (30”-36”), outdoor (36”-42”) • Is the range hood width the correct size for the cook top?• Outdoor units should...

34 34 Troublesh ooting Noisy Motor • Were the fan speeds checked fan speeds prior to installation?• Is the ducting clear?• Check to make sure motor is attached to housing• Is the backdraft damper on the transition piece functioning properly? Does it open when the hood is engaged? • If it is stuck, i...

WARRANTY COVERAGE ZLINE Kitchen and Bath range hood parts will be warrantied for three years from the original purchase date for the original purchaser of the product. ZLINE will provide free-of-charge, non-consumable replacement parts for the components that failed due to manufacturing defects. Add...