Yazoo/Kees ZKH61252 - Manuals

Page 2 - defects or other reproductive harm.

2 Continuous dedication to improve our products require that specifications and design aresubject to change without notice. Congratulations on the purchase of your Yazoo/Kees mower. This manual has been pre-pared for the owners and operators of the ZT MAX™ 52" and 61" commercial mowers. Read...

Page 3 - TABLE OF CONTENTS

3 TABLE OF CONTENTS SAFETY:1. Training2. Preparation3. Operation4. Transportation5. Maintenance SETUP AND ADJUSTMENTS:1. Park brake2. Cutting height3. Mower deck leveling4. Mule drive belt tension5.Throttle lever tension6. Reverse spring detent adjustment7. Motion control linkage adjustment OPERATIN...

Page 4 - SAFETY

4 SAFETY TRAINING:1. Read this manual carefully and question your dealer if something is not clear.2. Be thoroughly familiar with the controls and proper use of the equipment.3. Never allow children, teenagers, or people unfamiliar with these instructions to use themower.4. Do not mow while people, ...

Page 6 - EQUIPMENT SETUP AND ADJUSTMENTS; Figure 1

6 EQUIPMENT SETUP AND ADJUSTMENTS 1. Uncrate mower2. Mount drive wheels using the four lug nuts installed on the hub.3. Check tire pressure in all four tires. Pressure for all four tires is 15 psi4. Remove the motion control levers and install on the outside of the control arms (See figure1). Tabs o...

Page 8 - ADJUSTMENTS; Figure 3

8 ADJUSTMENTS MULE DRIVE BELT TENSION:1. Stop engine and remove the key.2. Check to make sure the bolt head in the spring loaded idler pulley, on the left side of theengine deck is positioned between the two alignment holes in the left support plate(See Fig 4).3. If adjustment is necessary, loosen t...

Page 11 - OPERATING INSTRUCTIONS

11 OPERATING INSTRUCTIONS NOTE: To begin motion the operator must be in the seat and the brake disengaged beforethe levers can be moved from the neutral slots or the engine will kill. By moving the levers an equal amount forward or back the mower will move in a straight linein that direction. Moveme...

Page 12 - Figure 6; WARNING

12 OPERATING INSTRUCTIONS STARTING AND OPERATION:1. Operator must be sitting in the seat. Engage park brake, blades off and place the motioncontrol levers in the neutral slots. (See figure 6)2. Adjust throttle to 1/2 and set choke (if needed) turn key and release as soon as enginestarts.3. Release p...

Page 13 - MAINTENANCE

13 5. Hardware: Stop engine and remove key thoroughly inspect the entire machine for any missing orloose hardware. Check daily. 6. Air cleaner: Stop engine and remove key. Remove plastic cover and loosen wingnut on the aircleaner. Remove the foam pre-cleaner and wash or replace if needed. Inspect pa...

Page 14 - (Clean grease zerk thoroughly before greasing)

14 13. Fuel filter: Replace annually or as needed. 14. Hydraulic filter and oil: Change every 500 hours or yearly. Stop engine and remove key.Tilt seat forward and clean around the filter and the fittings under the hydraulic tank. Removethe filter and allow any oil to drain from the filter head. The...

Page 17 - WIRING DIAGRAM

Page 18 - SERVICE RECORD; DESCRIPTION OF WORK DONE

18 SERVICE RECORD DESCRIPTION OF WORK DONE DATE SERVICE DONE BY