Yazoo/Kees ZKH52253 - Manuals

Page 2 - Congratulations; on the purchase of your; defects or other reproductive harm.

2 Continuous dedication to improve our products require that specifications and design aresubject to change without notice. Congratulations on the purchase of your Yazoo/Kees mower. This manual has been pre- pared for the owners and operators of the ZT MAX™ 52" and 61" commercial mowers. Rea...

Page 4 - mow excessively steep slopes

4 SAFETY TRAINING: 1. Read this manual carefully and question your dealer if something is not clear.2. Be thoroughly familiar with the controls and proper use of the equipment.3. Never allow children, teenagers, or people unfamiliar with these instructions to use themower.4. Do not mow while people,...

Page 5 - SAFETY; Use only authentic

5 SAFETY TRANSPORTATION: Use a heavy duty trailer to haul mower. Set park brake, turn off fuel valve and strap mower totrailer. NOTE: Park brake will not hold mower in place when transporting. Be sure to tie downthe mower to the trailer. Always back onto the trailer to prevent possible tipover. 1. K...

Page 6 - EQUIPMENT SETUP AND ADJUSTMENTS; Figure 1

6 EQUIPMENT SETUP AND ADJUSTMENTS 1. Uncrate mower2. Mount drive wheels using the four lug nuts installed on the hub.3. Check tire pressure in all four tires. Pressure for all four tires is 15 psi4. Remove the motion control levers and install on the outside of the control arms (See figure1). Tabs o...

Page 8 - Figure 3; THROTTLE LEVER TENSION:

8 ADJUSTMENTS MULE DRIVE BELT TENSION: 1. Stop engine and remove the key.2. Check to make sure the bolt head in the spring loaded idler pulley, on the left side of theengine deck is positioned between the two alignment holes in the left support plate(See Fig 4).3. If adjustment is necessary, loosen ...

Page 9 - ADJUSTMENTS

9 Figure 5A Figure 5B 5. If adjustment is necessary, loosen the nut against the yoke. Apply slight rearward pres-sure to the motion control lever and turn the head of the adjustment bolt in the proper direc-tion until the lever is centered in the neutral slot. NOTE: if properly adjusted the motionco...

Page 12 - Figure 6; WARNING; Mow only in daylight or good artificial

12 OPERATING INSTRUCTIONS STARTING AND OPERATION:1. Operator must be sitting in the seat. Engage park brake, blades off and place the motioncontrol levers in the neutral slots. (See figure 6)2. Adjust throttle to 1/2 and set choke (if needed) turn key and release as soon as enginestarts.3. Release p...

Page 13 - Thoroughly clean around cap before removing.; Remove oil drain cap; Thoroughly

13 5. Hardware: Stop engine and remove key thoroughly inspect the entire machine for any missing orloose hardware. Check daily. 6. Air cleaner: Stop engine and remove key. Remove plastic cover and loosen wingnut on the aircleaner. Remove the foam pre-cleaner and wash or replace if needed. Inspect pa...

Page 14 - MAINTENANCE; (Clean grease zerk thoroughly before greasing)

14 13. Fuel filter: Replace annually or as needed. 14. Hydraulic filter and oil: Change every 500 hours or yearly. Stop engine and remove key.Tilt seat forward and clean around the filter and the fittings under the hydraulic tank. Removethe filter and allow any oil to drain from the filter head. The...

Page 17 - WIRING DIAGRAM

Page 18 - SERVICE RECORD; DESCRIPTION OF WORK DONE

18 SERVICE RECORD DESCRIPTION OF WORK DONE DATE SERVICE DONE BY