11 3. Grasp the recoil starter handle and slowly pull the rope out. At the point where it becomes slightly harder to pull the rope, slowly allow the rope to recoil. stroke. Do not release the handle and allow it handle and allow it to slowly recoil. 5. As the engine warms, slowly rotate the choke co...
Page 3 - Heating Handle Switch
12 Fig. 13 The throttle control is located on the engine. It regulates the speed of the engine and will shut off the engine when pushed down to the end (tortoise) completely. (See Fig.13) Fig. 14 The auger control is located on the right handle. Squeeze the control grip against the handle to engage ...
Page 4 - MAINTENANCE
13 When engaged, the augers rotate and draw snow into the auger housing. Snow drawn into the auger housing is discharged out through the chute assembly. The chute clean-out tool is conveniently fastened to the rear of the auger housing with a mounting clip. Should snow and ice become clogged in the ...
Page 8 - CHECKING ENGINE OIL
17 4. Slip the drive belt off the pulley and between friction wheel and friction wheel disc. (See Fig.30). Fig. 30 5.Replace belt in the reverse order. If the snowblower fails to drive with the drive control engaged, and performing the drive control cable adjustment fails to correct the problem, the...
Page 9 - SERVICE AND ADJUSTMENT
18 Fig. 35 securely. tube. Note oil level. If oil reading on dipstick is below “LOW” mark, slowly add oil to reach “HIGH” level, (see Fig.35). tighten securely. 6. Wipe away any spilled oil. To avoid engine damage, it is important to: every 25 operating hours thereafter. recent use. 2. Be sure the g...
Page 11 - Preparing Snowblower
20 4. Remove the spark plug and pour one ounce of engine oil through the spark hole into the cylinder. Cover spark plug hole with a rag and crank the engine several times to distribute the oil. Replace spark plug. Preparing Snowblower 1. When storing the snow thrower in an unventilated or metal stor...