Whistler BT2300 - Manuals - manualsarea.com

Page 2 - Table of Contents

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-3What is Bluetooth ® ? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 3 - Customer Service; Introduction

Dear Whistler Owner, Thank you for purchasing a Bluetooth ® Headset from the Whistler Group. If you have questions concerning the operation of this Whistler product please call: Customer Service 1-800-531-0004 Monday - Friday • 8:00 am - 5:00 pm CT or visit our website www.whistlergroup.com Please k...

Page 4 - Safety Instructions; WARNING

Bluetooth is a wireless protocol utilizing short-range communications technology facilitatingdata transmissions over short distances from fixed and/or mobile devices, creating wirelesspersonal area networks (PANs). The intent behind the development of Bluetooth was the creation of a single digitalwi...

Page 6 - Storing and Recharging Headset

Storing When the unit is not in use please consider the following steps. 1). When not using the headset, please store it in a dry place and switch it off to save battery power. 2). Do not place it in direct sunlight or extremely hot temperatures. 3). Store all accessories in a dry place. Recharging ...

Page 8 - Installing Headset

Select mounting method based on helmet type. 1) Using Bracket A (for attaching to helmet)incl. 3M adhesive tape. Recommened to be placed on the left hand side 2) Using Bracket B (for attaching to the helmet) Please note: Not possible with every helmet type Please note: Equipment will vary due to hel...

Page 9 - Button Callouts

The volume adjustment will be acknowledged as tones through the speakers. Key Function [+] KEY [-] KEY MASTER KEY [M] TALK KEY [T] RESET MUTE KEY Button Callouts Button Functions 14 15 ACTIVATE/DEACTIVATE CHANNEL 2 INCREASE VOLUME ACTIVATE/DEACTIVATE CHANNEL 1 DECREASE VOLUME PAIRING CHANNEL 2 AS MA...

Page 10 - Basic Functions and Operation

Function Key/Action/LED Signal Normally, you can connect every Bluetooth cell phone to the headset. However,depending on the phone type, some functions cannot be operated through the headset.This includes the automatic music rendering after a call, redialing, or other functions.Therefore, if you hav...

Page 11 - Pairing to a Cell Phone

Connecting the headset with cell phone. 1). Activate the Bluetooth function of you phone and start searching for other phones in our environment. If necessary, make use of your mobile phone manual. Please make sure that all other Bluetooth devices in your environment as well as all channels of other...

Page 13 - Pairing to an Audio Device

Operating and disconnecting the audio device 1). You can adjust the volume of the audio device with the [+] & [-] keys of the headset. 2). You can start and stop the music with the Mute key. 3). If the audio device is out of range from the headset, the connection will be interrupted. 4). If the ...

Page 14 - Intercom Function

Vox Function (continued) 4). When activating the VOX after is has turned off, a delay of 3 seconds is required before resuming conversation. The activation of the VOX will provide a sound in the headset. 5). Depending on the helmet type and motorcycle, ambient noises could activate the VOX at higher...

Page 17 - Specifications

Technical Data BT2200/2300 BT3200/3300 Bluetooth version Version 2.0 Frequency 2.4 GHz ISM Band (2.4 – 2.4835 GHz) Output 0 dBm +17 dBm Bluetooth Class Class 2: 10m Class 1: 100m Channel/Devices 2/3 Operating Temperature -20 ~ 50 degrees C Dimensions 84(W) x 44.5(H) x 20.5(D) mm Weights 50g Specific...

Page 18 - Troubleshooting

Problem: The voice over the microphone is too low. Please make sure that the boom microphone is correctly placed close to your mouth. Thewhite marking has to be in the direction of your mouth (BT2200/3200). In addition, themicrophone sensitivity can be adjusted as required (page 24). Problem: The ca...

Page 19 - FCC Information

If this equipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to try tocorrect the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna.-- Increase...

Page 20 - Warranty Information

Service Under Warranty (continued) Due to the specialized equipment necessary for testing this product, there are no authorized servicestations for Whistler products other than Whistler. When returning a unit for service under warranty, please follow these instructions: 1. Ship the unit in the origi...