Whirlpool WFE505W0HZ0 - Manuals

5 Electrical Requirements Electrical Requirements - U.S.A. Only If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and wire gauge are in accordance with local codes.Do not use an extension cord.Be sure that the e...

6 INSTALLATION INSTRUCTIONS Unpack Range 1. Remove shipping materials, tape and film from range. 2. Remove oven racks and parts package from inside oven. 3. Do not remove the shipping base at this time. 4. On Ranges Equipped with a Storage Drawer: Remove the storage drawer. See the “Storage Drawer” ...

7 Install Anti-Tip Bracket 1. Remove the anti-tip bracket from where it is taped inside the storage drawer or warming drawer. 2. Determine which mounting method to use: floor or wall.If you have a stone or masonry floor, you can use the wall mounting method. If you are installing the range in a mobi...

10 4. Use a Phillips screwdriver to connect the green ground wire from the power supply cord to the range with the ground- link screw and ground-link section. The ground wire must be attached first. 5. Use ³⁄ 8 ” (1.0 cm) nut driver to connect the neutral (white) wire to the center terminal block po...

12 2. Attach terminal lugs to line 2 (red), bare (green) ground, and line 1 (black) wires. Loosen (do not remove) the setscrew on the front of the terminal lug and insert exposed wire end through bottom of terminal lugs. Securely tighten setscrew to torque as shown in the following Bare Wire Torque ...

13 Level Range Determine if you have AquaLift ® Technology or Steam Clean by referring to the “Range Care” section of the User Instructions. For Ranges with AquaLift ® Technology or Steam Clean: 1. Place level on the oven bottom as indicated in one of the two figures below depending on the size of t...

14 Storage Drawer (on some models) The storage drawer can be removed. Before removing, make sure drawer is cool and empty. To Remove: 1. Pull the storage drawer straight back to the drawer stop. 2. Lift up the front of the drawer and pull the drawer out. To Replace: 1. Lift up the front of the drawe...

15 If range does not operate, check the following: ■ Household fuse is intact and tight; or circuit breaker has not tripped. ■ Range is plugged into an outlet. ■ Electrical supply is connected. IMPORTANT: If the range control displays an F9 or F9, E0 error code, the electrical outlet may be miswired...

Si la cuisinière ne fonctionne pas, contrôler ce qui suit : ■ Les fusibles du domicile sont intacts et serrés; le disjoncteur n’est pas déclenché. ■ La cuisinière est branchée sur une prise électrique. ■ La prise de courant est correctement alimentée. IMPORTANT : Si le tableau de commande de la cuis...