Westinghouse WDF901SA - Manuals

Control panel 1 On/off button (POWER) 2 Program selection button (PROGRAM) 3 Delay start button (DELAY) 4 Start and Button lock button (START) 5 Start indicator light 6 Indicator lights 7 Digital display 8 Program indicator lights Indicator lights Button LOCK The indicator light comes on when the bu...

Important! It is not possible to deactivate the Button lock function while a delay orwashing program is in progress. To do thisyou must cancel the set program. Refer to'Select and start a washing program'. Setting mode The appliance is in setting mode when all theprogram indicator lights are on. The...

Turn the rinse aid dial to increase or decreasethe dosage.– Increase the dosage if there are water droplets or limescale on the dishes. – Decrease the dosage if there are streaks, whitish stains or bluish layers on thedishes. Wash hands to remove any residue ofrinse aid from skin. Loading cutlery an...

Cutlery basket Warning! Do not put long-bladed knives in a vertical position. Arrange long andsharp cutlery horizontally in the upperbasket. Be careful with sharp items. Use the cutlery grid for best washing results.If the dimensions of the cutlery prevent theuse of the cutlery grid, you can remove ...

Do these steps to move the upper basket tothe lower position:1. Pull the basket out until it stops.2. Carefully lift the two sides upwards.3. Hold the mechanism and guide it back down slowly. Caution! • Do not lift or lower the basket on one side only. • If the basket is in the upper position, do no...

Different brands of detergent dissolve indifferent times. Some detergent tabletsdo not have the best cleaning resultsduring short washing programs. Uselong washing programs when you usedetergent tablets to fully remove the de-tergent. Use of combi detergent tablets These products are detergents with...

Select and start a washing program 1. Close the appliance door.2. Press the on/off button.3. Make sure that the appliance is in setting mode. 4. Press one of the program buttons. Refer to the 'Washing programs' chart for pro-gram details.– The indicator light of the selected pro- gram stays on. All ...

Removing the load • First remove items from the lower basket, then from the upper basket. • There can be water on the sides and door of the appliance. Stainless steel becomescool more quickly than the dishes. Washing programs Washing programs Program Degree of soil Type of load Program description R...

Care and cleaning Warning! Switch the appliance off before you clean it. Cleaning the filters Caution! Do not use the appliance without the filters. Make sure that theinstallation of the filters is correct.Incorrect installation will causeunsatisfactory washing results anddamage to the appliance. If...

1. Disconnect the mains plug from the mains socket. 2. Close the water tap.3. Keep the door open to prevent unpleas- ant smells. 4. Keep the inner side of the appliance clean. Frost precautions Caution! Do not install the appliance where the temperature is below 0 °C.The manufacturer is not responsi...

The cleaning results are not satisfactory The dishes are not clean • The selected washing program is not applicable for the type of load and soil. • The baskets are loaded incorrectly so that water cannot reach all surfaces. • Spray arms do not turn freely because of incorrect arrangement of the loa...

Installation If floor is n ot level, adjustlevelling legs t o s uit POWE R S UPPL Y230/240V - 1 0 A mps The hos e s hould not beextended by more than2 metres or water pump-out problems m a y occu r Fix drain hose max of10mm below the top ofthe dishwashe r Remove entire plasticmembrane from sink trap...

• Attach the kick-panel to adjacent cabinets so that if service is necessary you can re-move it. Water connection Water inlet hose Connect the appliance to a cold water sup-ply.Connect the inlet hose to a water tap with anexternal BSP thread spout of 3/4”. Inlet water supply• Cold water pressure: 80...

The appliance has a security feature toprevent dirty water going back into theappliance. If, the spigot of the sink has a'non-return valve', this valve can causethe appliance to drain incorrectly. Re-move the non-return valve. Caution! Make sure that the water couplings are tight to prevent waterlea...

household waste disposal service or theshop where you purchased the appliance. Warranty FOR SALES IN AUSTRALIA AND NEW ZEA-LANDAPPLIANCE: AEG-ELECTROLUX This document sets out the terms andconditions of product warranties forElectrolux branded appliances. It is animportant document. Please keep it w...

– The Appliance is damaged by i) accidentii) misuse or abuse, including failure toproperly maintain or serviceiii) normal wear and teariv) power surges, electrical stormdamage or incorrect power supplyv) incomplete or improper installationvi) incorrect, improper or inappropriateoperationvii) insect ...