Weider WESY86303 - Manuals - manualsarea.com

Page 2 - TABLE OF CONTENTS; LIMITED WARRANTY

2 TABLE OF CONTENTS LIMITED WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....

Page 3 - IMPORTANT PRECAUTIONS

3 IMPORTANT PRECAUTIONS WARNING: To reduce the risk of serious injury, read the following important precautions beforeusing the training system. 1. It is the responsibility of the owner to ensure that all users of the training system are ade-quately informed of all precautions. 2. Read all instructi...

Page 4 - BEFORE YOU BEGIN

4 BEFORE YOU BEGIN ASSEMBLED DIMENSIONS: Height: 78 in.Width: 64 in. Length: 70 in. Foot Plate Low PulleyStation High Pulley Station Lat Bar Leg Lever Butterfly Arms Press Arm Weight Stacks Backrests Leg Press Plate Ab Pulley Station WARNING DECAL WARNING DECAL Thank you for selecting the versatile ...

Page 5 - ASSEMBLY

5 ASSEMBLY Make sure you have the following tools: • Two (2) adjustable wrenches • One (1) standard screwdriver • One (1) phillips screwdriver • One (1) rubber mallet • You will also need grease or petroleum jelly, a small amount of soapy water, and clear tape ormasking tape. Note: Assembly will be ...

Page 21 - IS

55 56 57 S E A T A S S E M B L Y M IS C . 21 58. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in HOW TO USE THE TRAINING SYSTEM, beginning on page 22 of this manual. Before using the training system, pull each cable a few times to be sure th...

Page 22 - HOW TO USE THE TRAINING SYSTEM

22 HOW TO USE THE TRAINING SYSTEM The instructions below describe how each part of the training system can be adjusted. Refer to the exerciseposter accompanying this manual to see how the training system should be set up for each exercise. IMPOR- TANT: When attaching the lat bar or nylon strap, make...

Page 24 - WEIGHT RESISTANCE CHART

24 WEIGHT RESISTANCE CHART This chart shows the approximate weight resistance at each weight station. “Top” refers to the 6.5 lb. top weight.The other numbers refer to the 12.5 lb. weight plates. The butterfly arm resistance listed is the resistance foreach butterfly arm. WEIGHT PRESS BUTTERFLY LEG ...

Page 25 - TROUBLE-SHOOTING AND MAINTENANCE

TROUBLE-SHOOTING AND MAINTENANCE Inspect and tighten all parts each time you use the training system. Replace any worn parts immediately. Thetraining system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents. TIGHTENING THE CABLES Woven cable, the type of cable us...

Page 26 - CABLE DIAGRAMS

26 CABLE DIAGRAMS The cable diagrams on this page and the next page show the proper routing of the High Cable (85), the LowCable (86), the Rear Cable (87), the Press Cable (88), and the Butterfly Cable (89). Use the diagrams to be surethat the Cables have been assembled correctly. The starting and e...

Page 32 - REMOVE THIS PART IDENTIFICATION

This chart is provided to help you identify the small parts used in assembly. Important: Some parts may have been pre-assembled for shipping purposes; if you cannot find a part in the parts bags, check tosee if it has been pre-assembled. REMOVE THIS PART IDENTIFICATION CHART FROM THE MANUAL! Please ...

Page 34 - IN

1 2 3 4 5 6 7 7 8 9 1 0 1 1 1 2 1 3 1 4 1 5 1 6 1 7 1 8 1 9 1 7 2 1 2 1 2 2 2 2 2 3 2 3 2 4 2 4 2 5 2 5 2 6 2 6 2 7 2 7 2 8 2 8 2 9 2 9 2 9 2 9 3 0 3 1 3 2 3 2 3 3 3 4 3 5 3 6 2 1 2 1 8 5 8 5 8 7 8 6 3 1 4 1 4 1 8 6 8 7 8 8 8 8 8 9 8 9 5 6 7 6 8 2 3 8 4 2 2 0 5 5 5 5 7 6 5 0 3 8 4 0 2 0 5 6 4 2 8 2 ...

Page 36 - ORDERING REPLACEMENT PARTS

ORDERING REPLACEMENT PARTS To order replacement parts, simply call our Customer Service Department toll-free at 1-800-999-3756, Mondaythrough Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). To help us assist you, please be pre-pared to give the following information: 1. The MODEL NUM...