Weider WESY49201 - Manuals - manualsarea.com

Page 2 - IMPORTANT PRECAUTIONS

1.Read all instructions in this manual and in the accompanying literature before using theweight system. 2.It is the responsibility of the owner to ensure that all users of the weight system are ade-quately informed of all precautions. 3.The weight system is intended for home use only. Do not use th...

Page 3 - BEFORE YOU BEGIN

3 BEFORE YOU BEGIN ASSEMBLED DIMENSIONS: Height: 78 in.Width: 86 in. Length: 66 in. Foot Plate High Pulley Station Lat Bar Leg Lever Butterfly Arms Assist Arm Press Arm Weight Stacks Backrests Dip Handles Pull-up Handles Warning Decal 1 Warning Decal 1 Warning Decal 3 Warning Decal 2 Leg Press Plate...

Page 4 - ASSEMBLY; FRAME

4 ASSEMBLY 1 8 8 11 51 27 1 4 3 1 51 5 1. Before beginning assembly, be sure thatyou have read and understand the infor-mation in the box above. Locate and open the parts bag labeled“FRAME ASSEMBLY.” Press two 2” Square Outer Caps (51) ontothe Stabilizer (5). Press a 2” Square InnerCap (27) into the...

Page 9 - ARM

9 12. Press a 1” Round Inner Cap (49) into one of the Press Arms (46). Press a 1 3/4” SquareInner Cap (44) into the Press Arm. Attach the Press Arm (46) to one side of thePress Frame (17) with two 5/16” x 2 1/2” Bolts(22) and two 5/16” Nylon Locknuts (3). Assemble the other Press Arm (46) in thesame...

Page 13 - CABLE

13 24. See the inset drawing. Attach a 3 1/2” Pulley (15) and a Cable Trap (66) to the upper hole ina Long “U”-Bracket (57) with a 3/8” x 2” Bolt(12) and a 3/8” Nylon Locknut (21). Be surethat the Cable Trap is inside the Long “U”-Bracket. Note: This may come pre-assem-bled. Route the High Cable (58...

Page 19 - SEA

19 40. Locate and open the parts bag labeled “SEAT ASSEMBLY.” Insert a 1/4” x 2 1/2” Carriage Bolt (92)through the center hole in a Seat Plate (37).Attach the Seat Plate to the Rear Backrest(85) with two 1/4” x 3/4” Screws (18). Insert the 1/4” x 2 1/2” Carriage Bolt (92)through the indicated hole i...

Page 22 - ADJUSTMENTS

22 ADJUSTMENTS The instructions below describe how each part of the weight system can be adjusted. Refer to the exerciseguide accompanying this manual to see how the weight system should be set up for each exercise. IMPOR-TANT: When attaching the lat bar or nylon strap, make sure that the attachment...

Page 24 - WEIGHT RESISTANCE CHART

24 WEIGHT RESISTANCE CHART This chart shows the approximate weight resistance at each weight station. “Top” refers to the 6.5 lbs. topweight. The other numbers refer to the 12.5 lbs. weight plates. The butterfly arm resistance listed is the resis-tance for each butterfly arm. WEIGHT PRESS BUTTERFLY ...

Page 25 - TROUBLE-SHOOTING AND MAINTENANCE

TROUBLE-SHOOTING AND MAINTENANCE Make sure all parts are properly tightened each time you use the weight system. Replace any worn parts immedi-ately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents. TIGHTENING THE CABLES Woven cable, the type ...

Page 26 - CABLE DIAGRAMS

26 CABLE DIAGRAMS The cable diagrams on these pages show the proper routing of the High Cable (58), the Low Cable (23), theMilitary Press Cable (72), and the Leg Press Cable (99). Use the diagrams to be sure that the four cables andthe cable traps have been assembled correctly. If the cables have no...

Page 28 - ORDERING REPLACEMENT PARTS; LIMITED WARRANTY

ORDERING REPLACEMENT PARTS To order replacement parts, simply call our Customer Service Department toll-free at 1-800-999-3756, Mondaythrough Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). To help us assist you, please be pre-pared to give the following information: 1. The MODEL NUM...

Page 30 - PART IDENTIFICATION CHART—Model No. WESY49201

5/16" Nylon Locknut (3) 1/4" Washer (10) 5/16" Washer (8) 1" Retainer (69) 3/8" Washer (9) 1/4" x 2 1/2" Screw (43) 3/8" Nylon Locknut (21) 1/4" x 2" Machine Screw (81) 5/16" Nylon Jamnut (93) 1/4" x 2 1/2" Carriage Bolt (92) 1/4" x 2" Carr...

Page 33 - REMOVE THIS PART LIST/EXPLODED DRAWING; SAVE THIS PART LIST/EXPLODED DRAWING FOR FUTURE REFERENCE

8 1 REMOVE THIS PART LIST/EXPLODED DRAWING FROM THE MANUAL. SAVE THIS PART LIST/EXPLODED DRAWING FOR FUTURE REFERENCE

Page 35 - EXPLODED DRAWING—Model No. WESY49201

60 27 21 50 55 86 11 8 15 12 44 88 15 58 21 44 21 3 61 62 24 3 58 71 2 65 108 64 25 26 19 9 3 3 49 6 22 46 46 16 3 9 15 21 59 23 21 17 27 1 4 10 43 41 42 21 3 50 31 86 70 69 69 70 21 47 44 45 44 45 48 50 31 86 13 40 38 37 18 32 34 30 28 3 49 83 33 10 2 36 14 15 29 35 30 34 34 30 28 21 9 32 30 34 10 ...