Weider WEEVSY87210 - Manuals

Page 3 - WARNING

The decals shown below have been placed on the weight system in the locations shown. If decals aremissing or illegible, please call our Customer Service Department to order free replacement decals (seethe back cover of this manual). Apply the decals in the locations shown. 3 • Misuse of thisproduct ...

Page 4 - BEFORE YOU BEGIN

4 BEFORE YOU BEGIN ASSEMBLED DIMENSIONS: Height: 188 cm (74 in.)Width: 102 cm (40 in.) Length: 135 cm (53 in.) Foot Plate Low Pulley Station High Pulley Station Lat Bar Seat Leg Lever Butterfly Arms Press Arm Weight Stack Weight Pin Backrest Stepper Pedals Resistance Cylinders Thank you for selectin...

Page 5 - ASSEMBLY; FRAME ASSEMBL

5 ASSEMBLY 1 56 High Side of Bracket Handles 3 5 51 Long Side 31 51 14 1 1 27 4 Before beginning assembly, carefully read thefollowing information and instructions: • Place all parts of the weight system in a cleared area and remove the packing materials; do notdispose of the packing materials until...

Page 9 - ARM ASSEMBL

9 ARM ASSEMBL Y 12. Wet the handle of one Press Arm (46) with soapy water. Slide a 5” Plastic Grip (31) ontothe handle. Press a 1” Round Inner Cap (49)into the other end of the handle. Press a 13/4” Square Inner Cap (44) into the top of thePress Arm. Attach the Press Arm (46) to one side of thePress...

Page 10 - CABLE ASSEMBL

10 CABLE ASSEMBL Y As you assemble the cables and pulleys insteps 14 through 22, please refer to theCABLE DIAGRAM on page 22 of this manual. 14. Route the Long Cable (23) around the 3 1/2” Pulley (15) attached to the Top Frame (55).Be sure that the end of the Cable with theball is on the indicated s...

Page 17 - HOW TO USE THE WEIGHT SYSTEM

17 HOW TO USE THE WEIGHT SYSTEM The instructions below describe how each part of the weight system can be adjusted. IMPORTANT: Whenattaching the lat bar or nylon strap, make sure that the attachments are in the correct starting positionfor the exercise to be performed. If there is any slack in the c...

Page 21 - TROUBLESHOOTING AND MAINTENANCE

21 TROUBLESHOOTING AND MAINTENANCE Inspect and tighten all parts often and replace any worn parts immediately. The weight system can be cleanedusing a damp cloth and mild non-abrasive detergent. Do not use solvents. TIGHTENING THE CABLES Woven cable, the type of cable used on the weightsystem, can s...

Page 22 - CABLE DIAGRAM

22 4 3 2 7 6 5 4 3 2 Weight Stack—8 1—Low Pulley 1—High Pulley Long Cable (23) 5—Long “U”-Bracket Short Cable (58) TOP VIEW CABLE DIAGRAM The cable diagram below shows the proper routing of the Short Cable (58) and the Long Cable (23). Use thediagram to be sure that the two cables and the cable trap...

Page 23 - NOTES

Page 24 - ORDERING REPLACEMENT PARTS

ORDERING REPLACEMENT PARTS If you encounter any difficulties or problems with this product, contact the ICON Fitness Lifestyle Ltd. office, orwrite: ICON Health & Fitness Ltd.Unit 4Revie Road Industrial EstateRevie RoadBeestonLeeds, LS118JGUK Tel: Country Code: Outside the UK: 0 (044) 113 387 71...

Page 28 - SAVE THIS PART LIST/EXPLODED DRAWING FOR FUTURE REFERENCE

81 REMOVE THIS PART LIST/EXPLODED DRAWING FROM THE MANUAL SAVE THIS PART LIST/EXPLODED DRAWING FOR FUTURE REFERENCE

Page 30 - EXPLODED DRAWING—Model No. WEEVSY87210

23 11 11 8 8 55 27 12 15 44 15 71 23 21 44 21 3 61 60 3 3 5 51 14 19 26 51 25 64 63 3 76 72 9 92 3 3 4 1 27 65 41 10 43 3 21 6 50 7 42 7 50 6 21 69 70 69 70 47 48 44 45 44 45 52 53 39 49 62 2 10 67 54 31 31 74 12 68 55 3 21 66 15 20 74 31 49 46 31 46 22 3 9 16 15 21 58 59 17 21 44 44 66 73 71 49 13 ...