Weed Eater 545186765 - Manuals

8 POWER CORD The POWER CORD is where you attach your extension cord to the unit. TRIGGER SWITCH The TRIGGER SWITCH is used to turn on the unit. Squeeze the trigger switch to operate the unit. Release to stop. LINE LIMITER PIN The LINE LIMITER PIN cuts the cutting line to the proper cutting length. T...

10 Edging Edging Direction SCALPING The scalping technique removes unwanted vegetation down to the ground. Hold the bot- tom of the trimmer head about 3 inches (8 cm) above the ground and at an angle. Allow the tip of the line to strike the ground around trees, posts, monuments, etc. This technique ...

11 Air Vents S Remove the wheel by pressing one of the buttons. Clean the wheel and groove on the motor housing with a soft brush. Reinstall wheel (see ASSEMBLY section). Groove SERVICE AND ADJUSTMENTS REPLACING THE LINE WARNING: Disconnect unit from power source before servicing.1. Press and hold i...

12 10. Place spool into hub with cut out area of spool in line with eyelets (see illustration). Cut out area of spool Eyelet 11. Remove one line from notch and feed line through eyelet. Repeat for second line. 12. Reinstall the spool cap. USER REPLACEABLE SERVICE PARTS Spool with 0.065 ″ Trimmer Lin...

14 LIMITED WARRANTY WEED EATER , a division of Husqvarna Con- sumer Outdoor Products N.A., Inc., warrants to the original consumer purchaser that each new WEED EATER brand electric or cordless pro- duct is free from defects in material and work- manship and agrees to repair or replace under this war...