Weed Eater 530163454 - Manuals

5 To avoid engine problems, empty the fuel sys-tem before storage for 30 days or longer.Drain the gas tank, start the engine and let itrun until the fuel lines and carburetor areempty. Use fresh fuel next season.Never use engine or carburetor cleaner prod-ucts in the fuel tank or permanent damagemay...

6 Do not run the engine at a higher speed thannecessary. The cutting line will cut efficientlywhen the engine is run at less than full throttle.At lower speeds, there is less engine noise andvibration. The cutting line will last longer and willbe less likely to “weld” onto the spool.Always release t...

7 Sweeping EDGING-- Adjust trimmer to the edging posi-tion (see TWIST AND EDGE section). Allowonly the tip of the line to make contact. Do notforce trimmer line into work area. Edging MAINTENANCE WARNING: Disconnect the spark plug before performing maintenance exceptfor carburetor adjustments. CHECK...

8 SERVICE AND ADJUSTMENTS LINE REPLACEMENT Pre--wound spools offer the most convenientmethod for replacing line and ensuring opti-mum performance. S Replacement spools are color--coded toensure use of the correct spool with yourunit. Be sure to use the same color spool asthe existing spool . NOTE: A...

9 STORAGE WARNING: Perform the following steps after each use: S Allow engine to cool before storing or trans-porting. S Store unit and fuel in a well ventilated areawhere fuel vapors cannot reach sparks oropen flames from water heaters, electricmotors or switches, furnaces, etc. S Store unit with a...

11 LIMITED WARRANTY ELECTROLUX HOME PRODUCTS, INC.,warrants to the original purchaser that eachnew Weed Eater " " " " brand gasoline tool or at- tachment is free from defects in material andworkmanship and agrees to repair or replaceunder this warranty any defective gasolineproduct o...