Page 2 - SAFETY RULES; OPERATOR SAFETY
2 SAFETY RULES WARNING: When using gardening appliances, basic safety precautions must al-ways be followed to reduce the risk of fire andserious injury. Read and follow all instruc-tions.This power unit can be dangerous! Operator isresponsible for following instructions and warn-ings on unit and in ...
Page 3 - ASSEMBLY; ADJUSTING THE HANDLE
3 CUTTING SAFETY WARNING: Inspect the area before each use. Remove objects (rocks, brokenglass, nails, wire, etc.) which can be thrownby or become entangled in line. Hard objectscan damage the trimmer head and be throwncausing serious injury. S Use only for trimming, scalping, mowing andsweeping. Do...
Page 4 - OPERATION
4 OPERATION KNOW YOUR TRIMMER READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. LineLimiterBlade Primer Bulb Fuel...
Page 5 - HOW TO START YOUR UNIT; OPERATING INSTRUCTIONS; OPERATING POSITION
5 EngineON/STOPSwitch Choke Lever FULL HALF OFF HOW TO START YOUR UNIT WARNING: The trimmer head will turn while starting the engine. Avoid any con-tact with the muffler. A hot muffler can causeserious burns. STARTING A COLD ENGINE (or awarm engine after running out offuel) Starting Position 1. Set ...
Page 6 - TRIMMER LINE ADVANCE; CUTTING METHODS
6 To stop engine: S Release the throttle trigger. S Push and release the engine ON/STOPswitch. TRIMMER LINE ADVANCE The trimmer line will advance approximately 2in. (5 cm) each time the bottom of the trimmerhead is tapped on the ground with the enginerunning at full throttle.The most efficient line ...
Page 7 - MAINTENANCE; CLEAN AIR FILTER; SERVICE AND ADJUSTMENTS; LINE REPLACEMENT
7 MAINTENANCE WARNING: Disconnect the spark plug before performing maintenance exceptfor carburetor adjustments. CHECK FOR LOOSEFASTENERS AND PARTS S Spark Plug Boot S Air Filter S Housing Screws S Assist Handle Screws S Debris Shield CHECK FOR DAMAGED ORWORN PARTS Contact an authorized service deal...
Page 8 - STORAGE
8 Hub Line exit hole Line in Notch 5. Wind the line evenly and tightly onto the spool. Wind in the direction of the arrowfound on the spool. 6. Push the line into the notche, leaving 3 to 5 inches (7 -- 12 cm) unwound. 7. Insert the line into the the exit holebin the hub as shown in the illustration...
Page 11 - EMISSION CONTROL WARRANTY PARTS
11 rights and responsibilities, you should contactyour nearest authorized service center or callELECTROLUX HOME PRODUCTS, INC., at1--800--554--6723 WARRANTY PERIOD: Anywarranted part which is not scheduled for re-placement as required maintenance, or which isscheduled only for regular inspection to ...