Weed Eater 530163351 - Manuals

7 8. Insert a small screwdriver into aligned holes. This will keep the shaft from turn- ing while tightening the blade nut. Screwdriver 9. TIghten blade nut firmly with a wrench while holding screwdriver in position. 10. Remove the screwdriver. 11. Turn blade by hand. If the blade binds against the ...

8 To avoid engine problems, empty the fuel sys- tem before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. Never use engine or carburetor cleaner prod- ucts in the fuel tank or permanent dam...

11 Cut using the 2 o’clock to 4 o’clock position of the blade 2 o’clock 4 o’clock RECOMMENDED CUTTING POSITION WARNING: The operator or others must not try to clear away cut material with the engine running or the blade turning to avoid serious injury. Stop engine and blade before removing materials...

12 SERVICE AND ADJUSTMENTS REPLACING THE LINE 1. Remove spool by firmly pulling on tap button. 2. Clean entire surface of hub and spool. 3. Replace with a pre-wound spool, or cut two lengths of 12-1/2 feet of 0.080 ″ (2 mm) dia- meter Weed Eater r brand line. WARNING: Never use wire, rope, string, e...