Weber SUMMIT GRILL CENTER - Manuals

6 www.weber.com ® opEratiNG The natural gas supply is easy to use and gives you more cooking control than charcoal fuel. • These instructions will give you the minimum requirements for assembling your Weber ® gas barbecue. Please read the instructions carefully before using your Weber ® gas barbecue...

7 www.weber.com ® Slide out bottom tray - Remove excess grease, then wash with warm soapy water, then rinse. flavorizer ® bars and Cooking grates - Clean with a suitable stainless steel bristle brush. As needed, remove from grill and wash with warm soapy water, then rinse with water. Catch pan - Dis...

8 www.weber.com ® Gas instructions ChECK for GaS lEaKS m warNiNG: the gas connections of your Summit ® gas grill have been factory tested. we do however recommend that you leak check all gas connections before operating your Summit ® gas grill. rEmoVE CoNtrol paNEl Part required: Phillips Screwdrive...

9 www.weber.com ® Gas instructions 3 1 2 A ChECK for GaS lEaKS m daNGEr do not use an open flame to check for gas leaks. be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion which can cause serious bodily injury or...

10 www.weber.com ® 3 1 2 7 6 4 5 Gas instructions Check: 1) Main gas line to manifold connection. 2) Rotisserie (I.R. Burner) gas line connection. 3) Bulkhead and gas supply hose connection. 4) Bulkhead to regulator connection. 5) Regulator to hose connection. m warNiNG: if there is a leak at connec...

11 www.weber.com ® A B C D E SNap iGNitioN opEratioN m always open the lid before igniting the burners Each control knob has its own igniter electrode built in. To create a spark you must push the control knob in (a) and turn to “START/High” (b) . This action will generate gas flow and a spark to th...

12 www.weber.com ® 3 1 2 4 5 liGhtiNG Summary lighting instructions are inside the left hand cabinet door. m daNGEr failure to open the lid while igniting the barbecue’s burners, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flame-up wh...

14 www.weber.com ® operatinG instructions GrilliNG tipS & hElpfUl hiNtS • Always preheat the grill before cooking. Set all burners on “HI” heat and close lid; heat for 10 minutes, or until thermometer registers 500˚-550˚F (260˚-288˚C). • Sear meats and cook with the lid down for perfectly grille...

15 www.weber.com ® operatinG instructions USiNG thE SEar StatioN ™ Your Weber ® gas barbecue includes a sear burner for searing meats such as steak, poultry parts, fish, and chops). Searing is a direct grilling technique which browns the surface of the food at a high temperature. By searing or brown...

16 www.weber.com ® operatinG instructions 1) Open the lid. 2) Make sure all burner control knobs are turned off. (Push control knob in and turn clockwise to ensure that it is in the “OFF” position.) 3) Turn on the gas supply at source. m warNiNG: do not lean over the open barbecue. 4) Ignite each ad...

19 www.weber.com ® operatinG instructions 1 3 2 6 7 8 9 4 5 maNUallY liGhtiNG thE SmoKEr bUrNEr 1) Open the lid. m daNGEr failure to open the lid while igniting the grill, or not waiting 5 minutes to allow the gas to clear if the grill does not light, may result in an explosive flare-up which can ca...

21 www.weber.com ® operatinG instructions liGhtiNG thE rotiSSEriE bUrNEr rotiSSEriE bUrNEr SNap iGNitioN Note: Each control knob snap igniter creates a spark from the igniter electrode to the burner lighting tube. You generate the energy for the spark by pushing in the control knob and turning to “S...

23 www.weber.com ® opEratiNG thE haNdlE liGht The Weber Grill Out ™ Handle Light has a built-in “Tilt Sensor.” With the power button (a) activated, the light will come on when the grill lid is open. The light will turn off when the lid is closed. For daytime use, deactivate the sensor by pressing po...

24 www.weber.com ® problEm ChECK CUrE rotisserie burner does not light. Did you hold the burner control knob in and hold in for 20 seconds until after burner ignited? Try to relight burner by holding burner control knob in and continue holding in until 20 seconds after burner has ignited. Did you wa...

25 www.weber.com ® maintenance rEplaCE maiN bUrNErS 1) Your Summit ® gas grill must be off and cool. 2) Turn gas off at source. 3) Disconnect gas supply. 4) Remove cooking grates. 5) Remove smoker box. 6) Remove Flavorizer ® bars. rEmoVE CoNtrol paNEl Part required: Phillips Screwdriver. • Remove th...

26 www.weber.com ® maintenance Be careful not to break or disconnect the wires for the control panel lights.Rest the control panel against the left side of the grill (a) exposing the valves, burners, igniter, and manifold. 8) Remove the two screws that secure the manifold to the cookbox. Pull manifo...

27 www.weber.com ® maintenance aNNUal maiNtENaNCE iNSpECtioN aNd ClEaNiNG of thE SpidEr/iNSECt SCrEENS To inspect the Spider/Insect screens, remove the control panel. If there is dust or dirt on the screens, remove the burners for cleaning the screens. Brush the Spider/Insect screens lightly with a ...

©2008 Weber-Stephen Products Co. All rights reserved. Printed in U.S.A. 55798_0708   Thanks for sharing your contact information with us. Again, it all stays strictly between us — Weber does not share customers’ names with anyone else. If you need replacement parts or have questions about the asse...