Weber S-440 - Manuals

6 WWW.WEBER.COM ® 1 1 2 2 3 1 2 Arrow stickers on Frame Rail (1) and Left Side Panel (2) should point toward each other (shown above). Door Stop Bracket (3) should be positioned as shown (left). ASSEMBLY

7 WWW.WEBER.COM ® 7 3 ATTENTION! Do not fully tighten screws. Clips should slide freely when installed. 4 ASSEMBLY

10 WWW.WEBER.COM ® CAUTION: Use two people to lift and install the Summit ® Built-In frame assembly. A.) Lift the frame assembly into the “island” structure opening. Make sure the frame is resting level on the fi nished surface of the structure. B.) Adjust the Front Vent to rest squarely on ground. ...

14 WWW.WEBER.COM ® S640 S440 a b c 15 Match Holder ASSEMBLY

20 WWW.WEBER.COM ® Table 10-1 Maximum Capacity of Pipe in Cubic Feet of Gas per Hour for Gas Pressures of 0.5 psi or Less and a Pressure Drop of 0.3 Inch Water Column. (Based on a 0.60 Specifi c Gravity Gas) Nominal Iron Pipe Size (Inches) Internal Diameter (Inches) Length of Pipe (Feet) 10 20 30 40...

21 WWW.WEBER.COM ® 21 GAS LINE PIPING • Refer to the piping chart at the bottom of previous page. • The corrugated gas line from the manifold is 58 inches (1,473.2 mm) long. Do not extend the gas line. • We have provided the means to make an SAE 45° fl are connection. Do not use pipe sealant on this...

23 WWW.WEBER.COM ® 23 LOCATING YOUR LP TANK ENCLOSURE KIT When determining a suitable location for your LP Tank Enclosure Kit installation, give attention to concerns such as proximity to traffi c paths, and keeping any gas supply lines as short as possible. Never locate the Summit ® LP Tank Enclosu...

24 WWW.WEBER.COM ® 4 8 4 1 2 4 2 2 PARTS LIST 2 Hose and regulator - 1 Tank stand - 1 Tank stand base - 1 Tank Scale - 1 1/4-20 nut - 6 Nylon washer - 12 1/4-20 x 1/2” bolt - 6 Cylinder glide - 2 1/2” Flare Gasket - 2 3/8” Flare Gasket - 2 PARTS LIST / ASSEMBLY

26 WWW.WEBER.COM ® A B C D E i ii iii iv v CONNECT GAS SUPPLY A 58 inch (1,473.2 mm) corrugated gas line is supplied with the grill. This line needs to pass through the gas inlet opening to the main gas supply. 1) Connect the corrugated gas line to the manifold located on the right hand side of gril...

27 WWW.WEBER.COM ® 27 VENTILATION WARNING: Air holes must be provided in the structure at the top and bottom to provide ventilation in the event of a gas leak. Air holes can be located in a low visibility area and should be protected by screening material to prevent rodents and insects from entering...