Weber Liquid Propane Gas - Manuals

B-1 Assembly Instructions (1) (2) Assemble wheel frameYou will need: axle rod, two wheel hubcaps, twowheels, wheel frame, hammer and a block of wood.Place one end of the axle rod on the block of wood (orother protected surface). Tap one hubcap onto the endof the axle rod. Slide one wheel onto the ax...

B-6 Fill liquid propane cylinderNote - The liquid propane cylinder manufacturer isresponsible for the materials, workmanship andperformance of the cylinder. If the cylinder has adefect, malfunctions, or you have a question regardingthe cylinder, call the cylinder manufacturer’s customerservice cente...

C-1 Installing Features (1) Install the right end trim piece with tool holdersand right swing-up work surfaceYou will need: Right trim piece with tool holders, rightswing-up work surface, swing-up work surface rod, one1/2 inch bolt, one nylon washer and a wrench1.) Start the right end trim piece int...

D-1 Lighting Summary lighting instructions are on the control panel. m DANGER Failure to open the lid while igniting thebarbecue’s burners, or not waiting 5 min-utes to allow the gas to clear if the barbe-cue does not light, may result in an explo-sive flame-up which can cause seriousbodily injury o...

D-4 Refilling the Liquid Pro-pane Cylinder We recommend that you refill the LP cylinder before itis completely empty. Removal of the LP cylinder 1) Close cylinder valve (turn clockwise).2) Unscrew regulator coupling by turning counter- clockwise, by hand only. 3) Loosen cylinder lock wing nut and tu...

D-6 Safe handling tips forLiquid Propane Gas Cyl-inders ■ Liquid Propane (LP) gas is a petroleum product as are gasoline and natural gas. LP gas is a gas atregular temperatures and pressures. Under moderatepressure, inside a cylinder, LP gas is a liquid. As thepressure is released, the liquid readil...

D-7 Annual Maintenance After a period of nonuse, we recommend that youperform the following maintenance procedures for yoursafety. m WARNING: Check the hose before each use of the barbecue for nicks, cracking, abrasions orcuts. If the hose is found to be damaged in anyway, do not use the barbecue. R...

D-8 General Maintenance Weber Spider Stopper™ Guards Your Weber Gas Barbecue, as well as any outdoor gasappliance, is a target for spiders and other insects.They can nest in the venturi section (Venturi(1), airshutter(2), venturi fin(3) ) of the burner tubes. Thisblocks the normal gas flow, and can ...

D-9 (1) (1) (1) (2) (1) Replacing Main Burners 1) Your Weber Gas Barbecue must be OFF and cool.2) Turn gas OFF at source.3) To remove control panel: take off the burner control knobs. Remove the screws holding thecontrol panel in place. Lift off the control panel. 4) Unlatch the Spider Stopper™ Guar...

D-10 Crossover® Ignition System Operations If the Crossover Ignition System fails to ignite the Leftburner, light the Left burner with a match. If the Leftburner lights with a match, then check the CrossoverIgnition System. ■ Check that both the white(1) and black(2) ignition wires are attached prop...

Troubleshooting Problem Check Cure Burners burn with a yellow ororange flame, in conjunction withthe smell of gas. Inspect Weber Spider StopperGuards for possible obstructions.(Blockage of holes.) Clean Weber Spider StopperGuards. (See Section “AnnualMaintenance”) Burners do not light. -or- Burnersh...