Weber A100.d - Manuals

B-1 Assemble wheel frame You will need: axle rod, two wheel hubcaps, twowheels, wheel frame, hammer and a block of wood.Place one end of the axle rod on the block of wood (orother protected surface). Tap one hubcap onto the endof the axle rod. Slide one wheel onto the axle, WEBERname facing out. Nex...

B-6 Install Gas SupplyGeneral Specifications for PipingNote - Contact your local municipality for buildingcodes regulating outdoor gas barbecueinstallations. In absence of Local Codes, you mustconfirm to the latest edition of ANSI Z223.1. WERECOMMEND THAT THIS INSTALLATION BE DONEBY A PROFESSIONAL. ...

C-1 Installing Features (1) Install the right end trim piece with tool holdersand right swing-up work surface You will need: Right trim piece with tool holders, rightswing-up work surface, swing-up work surface rod, one1/2 inch bolt, one nylon washer and a wrench1.) Start the right end trim piece in...

D-1 Lighting Summary lighting instructions are on the control panel. DANGER Failure to open the lid while igniting thebarbecue’s burners, or not waiting 5minutes to allow the gas to clear if thebarbecue does not light, may result in anexplosive flame-up which can causeserious bodily injury or death....

D-3 Cooking WARNING: Do not move the Weber Gas Barbecue when operating or while barbecue is hot. You can adjust the FRONT and BACK burners asdesired. The control settings: High (H), Medium (M),Low (L), or Off (O) are described in your Webercookbook. The cookbook uses these notations todescribe the s...

D-4 Annual Maintenance After a period of nonuse, we recommend that youperform the following maintenance procedures for yoursafety. WARNING: Check the hose before each use of the barbecue for nicks, cracking, abrasions orcuts. If the hose is found to be damaged in anyway, do not use the barbecue. Rep...

D-5 General Maintenance Weber Spider /Insect screens Your Weber Gas Barbecue, as well as any outdoor gasappliance, is a target for spiders and other insects.They can nest in the venturi section Venturi(1). Thisblocks the normal gas flow, and can cause the gas toflow back out of the air shutter. This...

D-6 (2) (1) Replacing Main Burners 1) Your Weber Gas Barbecue must be OFF and cool.2) Turn gas OFF at source.3) To remove control panel: take off the burner control knobs. Remove the screws holding thecontrol panel in place. Lift off the control panel. 4) Unhook the manifold bracket(1) and unscrew t...

D-7 Crossover® Ignition System Operations If the Crossover Ignition System fails to ignite the Leftburner, light the Left burner with a match. If the Leftburner lights with a match, then check the CrossoverIgnition System. ■ Check that both the white(1) and black(2) ignition wires are attached prope...

D-8 Troubleshooting Problem Check Cure Burners burn with a yellow ororange flame, in conjunction withthe smell of gas. Inspect Weber Spider/InsectScreens for possible obstructions.(Blockage of holes.) Clean Weber Spider/Insect Screens.(See Section “Annual Maintenance”) Burner does not light, or flam...