Weber 55143 - Manuals

B-1 Assembly Instructions W E B E R W EB E R (1) (2) Assemble wheel frame You will need: axle rod, two wheel hubcaps, twowheels, wheel frame, hammer and a block of wood.Place one end of the axle rod on the block of wood (orother protected surface). Tap one hubcap onto the endof the axle rod. Slide o...

C-1 Installing Features Install the right trim piece with tool holders You will need: Right trim piece with tool holdersPush the Right trim piece into the frame as shown(1),making sure that the tabs on the underside of the trimpiece are snapped into the slots in the frame.(2) C002.c (2) (1) Install ...

D-1 Lighting Summary lighting instructions are on the control panel. DANGER Failure to open the lid while igniting thebarbecue’s burners, or not waiting 5minutes to allow the gas to clear if thebarbecue does not light, may result in anexplosive flame-up which can causeserious bodily injury or death....

D-4 Refilling the LiquidPropane Cylinder We recommend that you refill the LP cylinder before itis completely empty. Removal of the LP cylinder 1) Close cylinder valve (turn clockwise).2) Unscrew regulator coupling by turning counterclockwise, by hand only. 3) Loosen cylinder lock wing nut and turn c...

D-5 Connecting the Liquid Propane Cylinder WARNING: Make sure that the LP cylinder valve is closed. Close by turning valve clockwise. DANGER Liquid Propane Cylinder The liquid propane cylinder manufacturer isresponsible for the materials, workmanship andperformance of the tank. If the tank has a def...

D-6 Safe handling tips forLiquid Propane GasCylinders ■ Liquid Propane (LP) gas is a petroleum product as are gasoline and natural gas. LP gas is a gas atregular temperatures and pressures. Under moderatepressure, inside a cylinder, LP gas is a liquid. As thepressure is released, the liquid readily ...

D-7 Annual Maintenance After a period of nonuse, we recommend that youperform the following maintenance procedures for yoursafety. WARNING: Check the hose before each use of the barbecue for nicks, cracking, abrasions orcuts. If the hose is found to be damaged in anyway, do not use the barbecue. Rep...

D-8 General Maintenance Weber Spider /Insect screens Your Weber Gas Barbecue, as well as any outdoor gasappliance, is a target for spiders and other insects.They can nest in the venturi section Venturi(1). Thisblocks the normal gas flow, and can cause the gas toflow back out of the air shutter. This...

D-9 (2) (1) (1) (1) (2) (1) Replacing Main Burners 1) Your Weber Gas Barbecue must be OFF and cool.2) Turn gas OFF at source.3) To remove control panel: take off the burner control knobs. Remove the screws holding thecontrol panel in place. Lift off the control panel. 4) Unhook the manifold bracket(...

D-10 Crossover® Ignition System Operations If the Crossover Ignition System fails to ignite the Leftburner, light the Left burner with a match. If the Leftburner lights with a match, then check the CrossoverIgnition System. ■ Check that both the white(1) and black(2) ignition wires are attached prop...

Troubleshooting Problem Check Cure Burners burn with a yellow ororange flame, in conjunction withthe smell of gas. Inspect Weber Spider/InsectScreens for possible obstructions.(Blockage of holes.) Clean Weber Spider/Insect Screens.(See Section “Annual Maintenance”) Burners do not light. -or- Burners...

1 Assembly Instructions Install manifold bracket You will need: manifold bracketHook the bracket(2) onto the manifold at the centerburner valve. Place your hand underneath the bracket.Lift the manifold and cooking box slightly, then hook thetab of the bracket on the frame brace(1). (1) (2) Addendum ...