Weber 42390 - Manuals

5 LOCATING YOUR LP TANK ENCLOSURE KIT When determining a suitable location for your LP Tank Enclosure Kit installation, give attention to concerns such as proximity to traffi c paths, and keeping any gas supply lines as short as possible. Never locate the Summit ® LP Tank Enclosure Kit in a garage, ...

6 4 8 4 1 2 4 2 2 PARTS LIST Hose and regulator - 1 Tank stand - 1 Tank stand base - 1 Tank Scale - 1 1/4-20 nut - 6 Nylon washer - 12 1/4-20 x 1/2" bolt - 6 Cylinder glide - 2 1/2" Flare Gasket - 2 3/8" Flare Gasket - 2 ASSEMBLY 2

7 MOUNTING THE LP TANK BRACKET Mount the LP tank bracket to the right hand side of the enclosure opening using non corrosive hardware. Mounting holes are provided on the sides and bottom of your LP tank bracket. Be sure to mount the bracket securley to the enclosure before use. MOUNTING HARDWARE NOT...

8 GAS INSTRUCTIONS 90ºfitting Connection to LP Tank Corrugated Gas Line to Manifold Cap (Optional Side Burner) Side View back of box top of box CONNECT GAS SUPPLY A 58 inch corrugated gas line is supplied with the grill. This line needs to pass through the gas inlet opening to the main gas supply. 1...

9 WARNING: Only use this grill outdoors in a well-ventilated area. Do not use in a garage, building, breezeway or any other enclosed area. CHECK THAT ALL BURNER VALVES ARE OFF Valves are shipped in the OFF position, but you should check to be sure that they are turned OFF. Check by pushing down and ...

10 If leak does not stop, Contact the Customer Service Representative in your region using the contact information sheet provided with your manual. Do not use the barbecue.8) When leak checking is complete, turn gas supply OFF at the source and rinse connections with water. GAS INSTRUCTIONS 6) Turn ...

11 GAS INSTRUCTIONS REFILLING THE LIQUID PROPANE CYLINDER We recommend that you refi ll the LP cylinder before it is completely empty. Removal of the LP cylinder 1) Close cylinder valve (turn clockwise). 2) Unscrew regulator coupling by turning counterclockwise, by hand only. 3) Loosen cylinder lock...

©2005- The following trademarks are registered in the name of Weber-Stephen Products Co., an Illinois corporation, located at 200 East Daniels Road, Palatine, Illinois 60067 U.S.A. Australia; Smokey Joe, Weber, Kettle Silhouette ® , Genesis, Austria; Kettle Silhouette ® , Smokey Joe, Weber, Benelux;...