Vizio WB-31 - Manuals - manualsarea.com

Page 2 - TABLE OF CONTENTS

WB-31 TABLE OF CONTENTS Parts List 4 Installation Tools 4 5 d u t s d o o W - n o it a ll a t s n I e t a l p k c a B 6 e c a f r u S e t e r c n o C - n o it a ll a t s n I e t a l p k c a B 7 n o it a ll a t s n I 1 3 - M W 8 r o ti n o M e h t g n il l a t s n I 9 m r A t u o g n i w S e h t g n ...

Page 3 - Warning Statements; WARNING

WB-31 Installation Instructions Page 3 Warning Statements WARNING : THE WALL STRUCTURE MUST BE CAPABLE OF SUPPORTING AT LEAST A MAXIMUM WEIGHT OF 50 LBS. IF NOT, THE WALL MUST BE REINFORCED. PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN, AS OUTLINED IN THE INSTALLATION INSTRUCTIONS...

Page 4 - Parts List; NOTE; Installation Tools

WB-31 Page 4 Installation Instructions Parts List NOTE : This mount is shipped with all intallation hardware and components. Make sure that none of these parts are missing and/ or damaged before beginning installation. If there are parts missing and/or damaged, please stop and contact TOA Electronic...

Page 5 - Backplate Installation - Wood Stud; Determine where the mount location will be.; . Backplate Installation

WB-31 Installation Instructions Page 5 Backplate Installation - Wood Stud NOTE : These installation instructions will apply to the WB-31 Swingout Arm Mount. The following steps will outline how the back plate will be mounted. 1. Determine where the mount location will be. 2. Use a stud finder (sold ...

Page 6 - Backplate Installation - Concrete Surface

WB-31 Page 6 Installation Instructions Backplate Installation - Concrete Surface NOTE : These installation instructions will apply to the WB-31 Swingout Arm Mount. The following steps will outline how the back plate will be mounted. 1. Determine where the mount location will be. 2. After this has be...

Page 8 - Cable Routing; Installing the Monitor; CAUTION; Figure 6; . Monitor Installation

WB-31 Page 8 Installation Instructions Figure 7. Cable Routing Installing the Monitor 1. Loosely tighten two (2) M4 x 10mm Phillips Head screws to the top of the mounting points. 2. Insert the head of the screws through the keyhole slots and then secure the bottom two (2) M4 x 10mm Phillips Head scr...

Page 9 - Adjusting the Swingout Arm; Figure 8; . Swing Arm Adjustment; caps

WB-31 Installation Instructions Page 9 Adjusting the Swingout Arm This unit comes pre-tensioned at the factory. To adjust the swingout Arm so that there will not be any move- ment, perform the following steps (Figure 8). 1. Remove the Plastic End Caps. 2. Take a 9/16” socket and ratchet and tighten ...

Page 10 - Adapter Plate Installation

WB-31 Page 10 Installation Instructions Adapter Plate Installation NOTE : If your flat panel is not a VESA 75/100, the 200x200 or the 100x200 Adapter Plates must be used. 100x200 Aapter Plate 1. Attach the 100x200 Adapter Plate to the back of the display using the provided hardware (see Parts List, ...

Page 11 - Technical Specifications

WB-31 Installation Instructions Page 11 Technical Specifications Figure 11. WB-31 Swingout Arm