Vizio C-CV454D-9 CU - Manuals

Page 2 - TABLE OF CONTENTS; SAFETY PRECAUTIONS

2 TABLE OF CONTENTS 1. SAFETY PRECAUTIONS ............................................................................... 3 2. GENERAL DESCRIPTION ............................................................................. 5 3. HANDLING PRECAUTIONS ....................................................

Page 3 - regarded as very important precautions are included.; Safety Symbol and Message Conventions; accidents that could result in personal injury.; WARNING

3 1. SAFETY PRECAUTIONS • Before installation or use, be sure to carefully read all the instructions in this section for correct and safe operation. • Make sure to observe the instructions in this manual as the conventions of safety symbols and messages regarded as very important precautions are inc...

Page 4 - CAUTION; Note

4 • Leave the installation of the unit to your TOA dealer because the installation requires expert experience and skills. The unit may fall off if incorrectly installed, resulting in possible personal injury. • Do not stand or sit on, nor hang down from the unit as this may cause it to fall down or ...

Page 5 - camera's plastic or other parts may be deformed or discolored.

5 2. GENERAL DESCRIPTION The TOA C-CV454 series are outdoor Day/Night cameras equipped with a 1/3" CCD.A lineup of cameras with three types of lenses, Wide, Standard, and Tele allows accurate monitoring over awide range from near to distant subjects depending on the installation location.Noise r...

Page 7 - mm; INSTALLATION AND CONNECTIONS

7 [Ceiling mounting example] [Wall mounting example] Bracket mounting boltwith washer, stainlesssteel (accessory) Camera mounting boltM8 or W3/8 Safety wire mounting hole Note Install a safety wire as needed. Select the wire considering its length, diameter, and hook strength. 1. Check the mounting ...

Page 10 - Attach the waterproof cap to the camera unit.

10 Fit the waterproof cap (shaded area) into place. 5. Attach the waterproof cap to the camera unit. Note If the waterproof cap is not secured to the mounting surface, water or moisture soaks in, causing the corrosionof the BNC connector. This may cause unit failure. Check to be sure that the waterp...

Page 11 - Notes; • If the Video output is not terminated at 75; Monitor

11 6. Connect the camera unit. Connect the camera unit to both the monitor and the power supply as illustrated below. Notes • If the Video output is not terminated at 75 Ω , camera images are not properly displayed. Make sure that the output has been terminated at 75 Ω at the connected monitor or sw...

Page 12 - Loosen two sunshade fixing screws.; Connect the camera’s monitor output terminal to the monitor.; Front cover

12 Loosen two sunshade fixing screws. Turn the sunshade, then extract it. 2. Connect the camera’s monitor output terminal to the monitor. Note: The camera will not operate if the monitor output terminal is connected to the camera drive unit. 3. Switch on the power supply. The power is supplied to th...

Page 14 - sunshade fixing screws.

14 Sunshade fixing screw(Screw with captive washer M3x8) Slot to insert the sunshadefixing screw Sunshade Sunshade fixing screw After inserting the sunshade, turn clockwise to fix it in position (as shown), then secure it with the sunshade fixing screws. [Ceiling mounting example] 7. After completin...

Page 15 - Mode Setting Switch; ABOUT MODE SETTING SWITCH; Set to “ON” position when annoying screen image flicker is detected.

15 Mode Setting Switch (Factory-preset setting) 1: Focus adjustment switch 2: Backlight compensation switch 3: Flickerless switch 4: ATW/AWB selection switch 5: Mode selection switch ATW D / N AWB COLOR F.ADJ BLC 1/100 1/60 ON OFF ATW D / N AWB COLOR F.ADJ BLC 1/100 1/60 ON OFF IRIS L H ON OFF ON OF...

Page 18 - Internal synchronization

18 9. SPECIFICATIONS C-CV454D-3 (CU) C-CV454D-9 (CU) C-CV454D18 (CU) 24 V AC, 50/60 Hz or 12 V DC4 W (300 mA, Maximum current: 800 mA) 1/3 type IT-CCD771 (H) x 492 (V), 380,000 pixels 2:1 interlaceHorizontal: 15.734 kHz, Vertical: 59.94 Hz VBS1.0 V(p-p), 75 Ω , RCA pin jack VBS1.0 V(p-p), 75 Ω , Wat...