Vivitar Vivicam 3695 - Manuals

Page 2 - Chapter 1 Introduction; -1 Safety Precautions

2 Chapter 1 Introduction Please read through this manual carefully before using your camera and follow the instructions to derive maximum benefit from your camera and avoid damage from improper operation. 1-1 Safety Precautions The software CD-ROM packaged with the camera is intended for PC use only...

Page 3 - -1 Product Description; Front View; Chapter 2 Getting to Know Your Camera; Rear View

4 TV-OUT Port USB Port 2-1 Product Description Front View Chapter 2 Getting to Know Your Camera (1) Flash (2) Lens Cover/ Power Switch (3) Lens (4) Shutter Button (5) Self-timer LED (6) Red-eye Reduction LED (7) Macro Switch (8) USB and TV Port Cover 5 Memory Card Slot Rear View (1) LCD Monitor (2) ...

Page 4 - -2 LCD Monitor Display; Chapter 3 Controls, Operation, and Display

6 2-2 Specifications ? Lens: focal length =7.5 mm, aperture F/2.8 ? Image Sensor: 2.0 mega pixel CMOS sensor ? Sensitivity: ISO 100 ? White Balance: Automatic, Sun, Tungsten, Fluorescent. ? Shutter: Electrical ? Shutter Speed: 1/4 to 1/2000 second ? Internal Storage: 16MB Internal Flash Memory ? Ext...

Page 5 - -8 Mode Display Button

8 3-3 Power Switch (lens cover) ? Slide the lens cover gently to the left to turn on the camera. You will hear a confirmation-tone sequence. When you turn on the camera, the red LED will be illuminate. When the Red LED goes OFF, the camera is ready. ? Slide the lens cover gently to the right to turn...

Page 6 - Chapter 4 Navigating Modes and Menus

10 3-9 Macro Switch ? The macro switch on the side of the camera changes the optical characteristics of your camera by adding an optical element in front of the lens. This allows you to take close up shots. Slide the Macro switch on the side of camera to switch between Normal and Macro modes. When y...

Page 8 - -5 PC Connection Selection

14 5. OSD (On Screen Display) Language 6. Date / Time 7. TV – Output Standard 8. Light Frequency Select the correct frequency type (50Hz or 60Hz) according to your regional electrical frequency. 9. Format Media Note: If a memory card is inserted, this function will only format the memory card, not t...

Page 9 - Chapter 5 Preparing Your Camera; -3 Inserting and Removing a Memory Card

16 5-1 Attaching the Hand Strap ? Insert the thin end of strap into the strap holder. . ? Pass the other end of strap through the loop. ? Stretch the strap tightly. 5-2 Loading Batteries ? Turn off the camera. Insert 2 AA batteries or a single CR-3V battery. Please make sure the batteries are full o...

Page 10 - -4 Setting Up the OSD Language; Chapter 6 Getting Started

18 ? Press the memory card down momentarily and gently. ? The memory card will click and bounce upward. ? Pull the memory card out with your fingers direction. NOTE: If the memory card is full of images or data, you can turn the Mode Dial to Setup Mode and then select " Format " to format th...

Page 12 - -1 Installing the PC Camera Driver; Chapter 7 Driver Installation

22 6-6 TV Output You can display your images on a standard TV as follows: 1. Please select the video standard that matches the TV you wish to use. Turn the Mode Dial to Setup Mode and select NTSC or PAL. 2. Use the TV cable provided with the camera to connect the camera and output device. 3. Turn on...

Page 13 - -2 Installing PC Application Software

24 7-2 Installing PC Application Software Install the Arcsoft Software (Photo Impression shown as an example) 1. Insert the V3695 CD-ROM into your CD-ROM drive. 2. The CD will Auto-run and the welcome screen appears: (If your CD-ROM does not auto-run double click on the " My Computer " icon ...