Viking VCWB300 - Manuals - manualsarea.com

Page 2 - Table of Contents

Table of Contents Technical Information--------------------------------------------------------------------- 4 Sealed System------------------------------------------------------------------------------ 5 Control Panel Assembly------------------------------------------------------------------- 6 Mod...

Page 4 - SEALED SYSTEM

SEALED SYSTEM The sealed system consists of the following components (listed in order of refrigerant flow): 1 condenser coil 1 dryer assembly 3 solenoid valves 3 heat exchangers 3 evaporators 1 compressor 1 discharge tube 1 drain pan heater 1 pre-condenser loop Refrigerant Type – HFC 134a Refrigeran...

Page 5 - CONTROL PANEL ASSEMBLY; Microprocessor based 3 – channel temperature / logic control.; Normal cooling operation:; Control will independently read and regulate the average

CONTROL PANEL ASSEMBLY The wine cooler is equipped with a control panel conveniently located in the top front of the top compartment of the wine cooler. From this point the user can operate all functions of the wine cooler’s temperature management and various electronic features. The control panel h...

Page 6 - Temperature readout and setting:; Pressing the zone button will change which chamber; Compressor protection:; At any time the compressor needs to start, including that power

and appropriate zone valve based upon the temperature at the evaporator thermistor and will turn off the zone valve based upon the temperature at the chamber thermistor. Temperature readout and setting: Pressing the zone button will change which chamber is selected for adjustments. The selected cham...

Page 7 - (Note: The Display must be “on” before entering

Showroom mode: This mode, selected by closing the showroom switch is intended to simulate normal operation in all ways except the cooling and temperature alarm functions. Closure of this switch will over-ride normal cooling. Temperature displayed for the chambers will be the last temperatures stored...

Page 8 - GLASS MULLION SHELF; with respect

GLASS MULLION SHELF Each compartment is separated be a fixed glass shelf (“Mullion” – two per wine cooler). These glass shelves are uniquely designed such that they act not only as an insulated divider wall, but also provides a means of draining the condensate water from the top and middle compartme...

Page 9 - DISPLAY PANEL KEYBOARD; ELECTRONIC FUNCTION DESCRIPTION

DISPLAY PANEL KEYBOARD ELECTRONIC FUNCTION DESCRIPTION Power Disconnect Switch: The power on/off switch is used to turn the power off to the wine cooler when cleaning it or changing the light tubes. The wine cooler is shipped with the power on/off switch in the on position. To turn the power off, re...

Page 12 - LEVELING ADJUSTMENTS; DOOR STOP ADJUSTMENT; The pin is factory set 110; HINGE ADJUSTMENT

LEVELING ADJUSTMENTS DOOR STOP ADJUSTMENT 1. Using a 3/16” allen wrench, remove door stop pin located in bottom hinge. 2. The pin is factory set 110 ° . For 120 ° swing, move the pin to the utmost forward stop hole. For 90 ° swing, move the pin to the utmost rear stop hole. HINGE ADJUSTMENT 1. Using...

Page 18 - VCWB300 WIRING SCHEMATIC

Page 19 - VCWB300 WIRING DIAGRAM

Page 20 - in all Wine storage

TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE CORRECTION A. Warm temperature 1. Control set too warm Check set-points. Adjust set- in all Wine storage points colder. compartments. 2. Unit in Showroom Adjust set-points and listen Mode for compressor and condenser fan operation. If they do not energize...

Page 21 - Control Set too Warm; in only one wine; Unit Recently Energized

TROUBLESHOOTING GUIDE (con’t) PROBLEM POSSIBLE CAUSE CORRECTION A. Warm temperature b2 Check for continuity across In all Wine Storage the motor windings of the Compartments. inoperative fan motor (See pages 14 and 19). 8. Condenser Air / Flow Condenser Fan Fault a. Dirty condenser a. Clean condense...