Page 2 - Please Read and Follow!
Table of Contents IMPORTANT– Please Read and Follow! 2 3 Fire/explosion hazard. IF THE INFORMATION INTHIS MANUAL IS NOTFOLLOWED EXACTLY, A FIRE OR EXPLOSION MAY RESULTCAUSING PROPERTY DAMAGE,PERSONAL INJURY, OR DEATH. • DO NOT store or use gasoline or other flammable vapors and liquids in thevicinit...
Page 3 - Flip Cap
4 LP Orifice Conversion Kit Contents Excludes models VGR, VCM, VRT, VRT-R and D3 models. For information on these models, please contact customer service at 1-888-845-4641. 5 Regulator Conversion Flip Cap Hex Nut Cap Before proceeding with conversion, turn off gas supply and disconnect power to unit...
Page 4 - Infrared Broiler Conversion; Preparing for Top Surface Conversion; Surface Burner Conversion
7 6 Infrared Broiler Conversion IMPORTANT: The infrared broiler orifice must be changed from rear of range before unit is installed. Locate bag labeled IR Broiler Orifice. Remove nutsecuring 90degree fitting andbroiler tubing torear of range. Remove Orifice from 90 degree fitting and replace with or...
Page 6 - Orifice Locations; Open Burner Type 3
11 10 Orifice Locations (#61) (#63) (#61) (#67) (#57) (#65) (#65) (#57) (#67) DGRT301 DGRT361 (#60) (#67) (#58) (#70) DCCG130 DSCD130 Open Burner Type 3 Surface Burner Conversion Locate bag labeled Open Burner Orifice Type 3.Remove screws securing open surface burner to burner box and remove open su...
Page 7 - U-Shape Burner with Spark Ignition; Straight Tube Burner with Spark Ignition
13 12 Griddle Conversion (for models equipped with griddle) U-Shape Burner with Spark Ignition Locate bag labeled Griddle Orifice.Remove screws securing griddle venturi plate to griddle box and remove griddle venturi plate.Remove screws securing griddle burner to burner box.Loosen air shutter screw ...
Page 8 - Straight Tube Burner with Glow Bar Ignition
15 14 Straight Tube Burner with Glow Bar Ignition Remove screws securing glow bar igniter to burner box and place glow bar igniter aside.Remove screws securing metal plate to burner box located underneath griddle burner andremove metal plate.Remove screws securing griddle burner to unit and remove g...
Page 9 - Wok Conversion; Overhead; Bake Conversion; “L” Shaped
17 16 Wok Conversion (for models equipped with wok) Remove center trivet and/or grates, center ring and grate support.Lift and remove burner from unit.Loosen air shutter screw and adjust opening on burner to 5/8” and tighten air shutter screw.Remove orifice by turning counterclockwise and replace wi...
Page 10 - “U” Shaped; Rating Label Locations
19 18 Bake Conversion “U” Shaped Remove oven racks and rack supports.Remove oven bottom.Remove screws securing bake igniter to bake burner.Remove screws securing bake burner shield to oven burner box.Remove screws securing bake burner to oven burner box.Loosen air shutter screw and adjust opening on...