Page 2 - IMPORTANT; Please Read and Follow; DANGER; Table of Contents
IMPORTANT • Before beginning, please read these instructions completely and carefully. • DO NOT remove permanently affixed labels, warnings, or plates from product.This may void the warranty. • All local and national codes and ordinances must be observed. Installationmust conform with local codes or...
Page 4 - 0” Gas Cooktop; Professional Gas Cooktops
Specifications (VGSU Professional) 7 Dimensions (VGSU Professional) 6 21 ” (53 .3 cm ) 30-3 /4” (78.1 cm ) 21 ” (53 .3 cm ) 36-3 /4” (93.3 cm ) 1” (2.5 cm) 2-1/2” (6.4 cm) 5” (12.7 cm) 13/16” (2.1 cm) 6-19/32” (16.7 cm) 30” Gas Cooktop 36” Gas Cooktop Professional Gas Cooktops Description VGSU104 VG...
Page 5 - Designer Gas Cooktops
Specifications (DGSU Designer) 9 Dimensions (DGSU Designer) 8 21 ” (53 .3 cm ) 30-3 /4 ” (78.1 cm ) 21 ” (53 .3) 36-3 /4 ” (93.3 cm ) 30” Gas Cooktop 36” Gas Cooktop 2-1/4” (5.7 cm) 4-3/8” (11.1 cm) 1-3/4” (4.5 cm) Designer Gas Cooktops Description DGSU101 DGSU161 Overall width 30-3/4” (78.1 cm) 36-...
Page 7 - Clearance Dimensions; Cutout Dimensions; Downdraft Dimensions
Clearance Dimensions (Proximity to Cabinets) 13 36 ” m in. (91 .4 cm ) 13 ” m ax . ( 33 .0 cm ) 8” m in. (20 .3 cm ) 18 ” m in. (45 .7 cm ) A 36 ” m in. ( 91 .4 cm ) Proximity to Side Cabinet Installation • The cooktop may be installed directly to existing base cabinets. • The cooktop CANNOT be inst...
Page 8 - Electrical & Gas Requirements; Wall Installation
Electrical & Gas Requirements Electrical Requirements There is no connection necessary beyondplugging the unit into a polarized,grounded, 120 volt, 60 Hz, 15 amp circuit. Aminimum of 120VAC is required for properoperation of gas ignition systems. DO NOT use a GFI circuit. This circuit, however, ...
Page 9 - General Information; CAUTION
General Information • All openings in the wall behind the appliance and in the floor under theappliance shall be sealed. • Keep appliance area clear and free from combustible materials, gasoline, and otherflammable vapors. • DO NOT obstruct the flow of combustion and ventilation air. • Disconnect th...
Page 10 - DGSU Bracket Installation; Installation
19 Cooktop Bracket Screw Countertop 1 Cooktop Bracket Countertop Eye Bolt 2 Screw hold down brackets using the #10 x 1/2” sheet metal screw to the burner box. Screw the eye bolt into the self-retaining nut and tighten firmly against bottom of countertop. Cooktop Bracket Countertop 1 Cooktop Bracket ...
Page 11 - Service & Registration; Performance Checklist; Final Installation
Service & Registration Only authorized replacement parts may be used in performing service on the appliance.All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the nearest service partsdistributor in your area or write to: V...