Viking F20513 - Manuals - manualsarea.com

Page 2 - DANGER

IMPORTANT– Read and Follow! 3 2 Table of Contents • Before beginning, please read these instructions completely and carefully. • Do not remove permanently affixed labels, warnings, or plates from product. This mayvoid the warranty. • All local and national codes and ordinances must be observed. Inst...

Page 3 - IMPORTANT–

IMPORTANT– Read and Follow! 5 4 DANGER GAS LEAK HAZARD To avoid risk of personal injury or death; leak testing of the appliance must be conducted according to the manufacturer’s instructions. Before placing appliance in operation, always check for gas leaks with soapy water solution. • DO NOT USE AN...

Page 5 - Clearance Dimensions; CAUTION

42 ” m in. (10 6.7 cm ) 13 ” m ax . ( 33 .0 cm ) 6” min . (15.2 cm ) 18 ” m in. (45 .7 cm ) 3/ 8” (0. 95 cm ) 36 ” ( 91 .4 cm ) 29-7 /8” (75.9 cm ) Clearance Dimensions (Wood/Composite Overlay) 9 Clearance Dimensions (Proximity to Cabinets) 8 • This range may be installed directly adjacent to existi...

Page 6 - WARNING; Electrical & Gas Requirements

11 Electrical & Gas Requirements 10 Electrical Requirements Check your national and local codesregarding this unit. This range requires120VAC/60 Hz; 4 ft. (121.9 cm), 3-wire cordwith grounded 3-prong plug attached tounit. See “Electrical Connection” section forgrounding instructions. Must be fus...

Page 7 - General Information; NOTICE; Door Removal; Installation

13 12 General Information READ AND FOLLOW ALL WARNINGAND CAUTION INFORMATION WHENINSTALLING THIS APPLIANCE. • All openings in the wall behind the appliance and in the floor under theappliance must be sealed. • Do not obstruct the flow of combustion and ventilation air. Moving, Handling, and Unpackin...

Page 8 - Leg Installation

14 15 1 1 1 2 3 2 Legs are packed in styrofoam top pack. Note: Legs should be installed near to where appliance is to be used, as they are not secure for long transit. Note: It is strongly recommended that a pallet or lift jack be used rather than tilting. Raise unit about a foot. Unscrew temporary ...

Page 9 - Connecting Gas & Electric; Anti-tip Device Installation

17 16 1 Me asu rem ent (A) Measur ement (A) Me asu rem ent (A) 2 Me as ure me nt (A ) Measur ement (A) +1 /2 ” +1/2” (1. 3 c m) (1.3 cm) Me as ure me nt (A ) +1 /2 ” (1. 3 c m) 3-5 /8” 3-5/8” (9.2 cm ) (9.2 cm) 3-5 /8” (9.2 cm ) Measure from floor to bottom of the anit-tip opening located on the bac...

Page 10 - Door Replacement and Adjustment; Final Installation

18 19 1 2 Reattach door to range. Open door completely. Reattach hinge trim. 3 4 Remove pins from hole in hinges. Close door. 5 If the door needs to be adjusted, loosen hinge trim screws located in step 2. Adjust the screws located between the door and kickplate using a 5/32” hex head allen wrench. ...

Page 11 - Service & Registration

21 20 Only authorized replacement parts may be used in performing service on the appliance.All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (854-4641), for the nearest service partsdistributor in your area or write to: VIKING RANGE CORPORATI...