Viking AD128128M - Manuals

AD6464M / AD128128M Rev. 5 2 Specifications 2.1 Mechanics Dimensions: HxWxD = 220x483x340mm, (19”, 5RU). Backplane card: 128x128 AES/EBU Digital Audio. X-point Modules: 64x64 AES/EBU Digital Audio module cards. System Controller: 1 SysCon card required, must be specified, 1 redundant card is optiona...

AD6464M / AD128128M Rev. 5 Synchronisation handled by SysCon 1 : − Analogue Black Burst, Looped. Both PAL and NTSC supported. − Tri-Level, Looped. For HD signal formats only. Connector: 75 ohm BNC female, loop-thru. Optional Features: Redundant control: Redundant Matrix Control using 2x SysCon. TCP/...

AD6464M / AD128128M Rev. 5 2.5 Rear view Figure 1: Rear view The following service connectors can be found on the rear of the Modular AES/EBU Digital Audio Router: − AC Mains A : AC mains power supply. − AC Mains B : AC mains power supply (if redundant PSU is installed). − Serial A1 and A2 : RS-232 ...

AD6464M / AD128128M Rev. 5 3 Modules inside the Modular AES/EBU Digital Audio Router In order to get an overview of the parts that form the Modular AES/EBU Digital Audio Router this chapter will highlight some of the main components. GYDA-VX (not shown in picture) SysCon Power Supplies X-point Modul...

AD6464M / AD128128M Rev. 5 Figure 3 3.3.1 Module insertion In order to insert a power supply module one must insert the module via the special plastic guide rails into its position. Once the module is inserted, fix the module by lifting up the handle on the front and pushing it to the upright positi...

AD6464M / AD128128M Rev. 5 − The PSU module A alarm is formed by contact between Pin 3 and Pin 6 (Green pair) − The PSU module B alarm is formed by contact between Pin 1 and Pin 2 (Orange pair) Figure 4 3.4 System Controller – SysCon Each VikinX.128 frame comes with either one or two system controll...

AD6464M / AD128128M Rev. 5 Figure 6 On the top of the card tray, there is a hole above each module slot. When the tip of the handle is just below this hole, start to push the handle downwards as in the figure. The tip of the handle enters the hole and the card is locked and proper contact ensured wh...

AD6464M / AD128128M Rev. 5 3.6.4 Service switches and Reset button There are two slide-switches and one push-button switch on the card, as shown in the figure below. Reset button Service switches Figure 15 The push-button switch is the RESET switch. When this button is pushed and released, the µCont...

AD6464M / AD128128M Rev. 5 4 Router communication You gain access to router for communication purposes by connecting either the router’s serial port to your computer and/or by using an Ethernet connection. 4.1 Serial connection Connection can by made trough the serial port(s) of the router; see also...

AD6464M / AD128128M Rev. 5 5 Connecting signal cables to the router Below you will find our standard pin-out for DB25 audio contacts. This pin-out is used for both analogue and digital audio routers. The same standard is used by Tascam and Fostex. DB25 Pin # Channel # Hot (+) Cold (-) GND 1 24 12 25...

AD6464M / AD128128M Rev. 5 6 Before calling Network Support The following table shows possible symptoms, and what to do in order to correct possible error sources. Every user should read this before calling Network Technical Support. Symptom What to do… The lower, GREEN LED on the Power Supply is OF...

AD6464M / AD128128M Rev. 5 7 Serial number overview The following table shows the serial numbers of all parts of your Modular AES/EBU Digital Audio Router. Please refer to these numbers when contacting Network Electronics ASA for product support. Device / Part Part / Serial number Frame, including a...

AD6464M / AD128128M Rev. 5 Product Warranty The warranty terms and conditions for the product(s) covered by this manual follow the General Sales Conditions by Network Electronics ASA. These conditions are available on the company web site of Network Electronics ASA: www.network-electronics.com netwo...

AD6464M / AD128128M Rev. 5 Notes network-electronics.com | 26

AD6464M / AD128128M Rev. 5 Appendix A Materials declaration and recycling information A.1 Materials declaration For product sold into China after 1st March 2007, we comply with the “Administrative Measure on the Control of Pollution by Electronic Information Products”. In the first stage of this leg...

AD6464M / AD128128M Rev. 5 50 It is assumed that while the product is in normal use, any batteries associated with real-time clocks or battery-backed RAM will be replaced at the regular intervals. The EFUP relates only to the environmental impact of the product in normal use, it does not imply that ...