Viking 200 - Manuals - manualsarea.com

Page 2 - IMPORTANT–; Please Read and Follow!; Site Preparation; W A R N I N G; Table of Contents

IMPORTANT– Please Read and Follow! 3 Site Preparation It is recommended that a thorough site inspection beconducted PRIOR to unpacking and moving this appliance. W A R N I N G Make sure that incoming voltage is the same as unit rating. An electric rating plate specifying voltage, hertz, and amps is ...

Page 4 - Dimensions & Cutout Dimensions; Designer Series; Specifications

Dimensions & Cutout Dimensions 6 7 23-7/8” (60.6 cm ) 28 - 3/4 ” (73 .0 c m) 33-7/8” (86.0 cm ) 49” (12 4.5 cm) 26-3/8” 23-3/4” 2-5/8” 26-3/8” 23-1/8” 3-3/16” Cabinet Flush Panel Flush 26-3/8” 23-1/8” 2-7/8” 26-3/8” 23-3/4” 2-1/4” Panel Flush Cabinet Flush 23-1/8” 23-3/4” Panel Flush Cabinet Flu...

Page 5 - Custom Door Panel

11-17/32" (29.3 cm) 29-3/4" (75.6 cm) to 31-1/4” (79.4 cm) 22-21/32" (57.5 cm) 23-9/32" (59.1 cm) with trim or 23-7/8” (60.6 cm) without trim 10" (25.4 cm) 10-5/8" (27.0 cm) 5/8" (1.6 cm) 5/8" (1.6 cm) 5/8" (1.6 cm) ø1/8" 4 places (.3 cm) Use 1/4" router b...

Page 6 - Electrical Connections; General Information

Electrical Connections Grounding Instructions This appliance must be grounded. In theevent of a malfunction or breakdown,grounding will reduce the risk of electricshock by providing a path of least resistancefor electric current. This appliance isequipped with a cord having an equipment-grounding co...

Page 7 - Hardwire Conduit Option; Trim Installation Options

UL approvedstrain relief d Common Green Ground White Black Run wires through bottom pan. Using a UL approved strain relief, connect wires to terminal block. e Green Ground Connect ground wire. NOTE: Reinstall front plate and bottom pan. 12 13 Hardwire Conduit Option a 1 b Remove any loose items in t...

Page 9 - Counter Balance Spring Adjustment - If Necessary; Installation Procedure

Disconnect cable from hook. a Set counter balance spring connector in appropriate location. 2 1 b Increase tension Decrease tension Reconnect cable to hook. c Counter Balance Spring Adjustment - If Necessary NOTE: For custom panel installation, the door mayrequire adjustment to thepreload of the cou...

Page 11 - Performance Checklist; Testing for Leaks; Final Preparation; Unit Reset

20 21 Installation Procedure (cont’d.) 11A Air Gap (Discharge with food waste disposer and air gap) 11B Air Gap (Discharge with air gap) Connect water line. 12 13 Plug LED light into dishwasher (select models only) and install kick plate. Performance Checklist Testing for Leaks A qualified installer...

Page 12 - Service & Registration

23 22 Only authorized replacement parts may be used in performing service on the appliance. Do notrepair or replace any part of the appliance unless specifically recommended in the manual. Allservicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845...