ViewSonic VX900 - Manuals

Quick Installation 2 Connect video cable • Make sure both the LCD display and computer are turned OFF • Remove rear panel covers if necessary• Connect the video cable from the LCD display to the computer Macintosh users: Models older than G3

Using the LCD Display Setting the Timing Mode Setting the timing mode is important for maximizing the quality of the screen image and minimizing eye strain. The timing mode consists of the resolution (example 1280 x 1024) and refresh rate (or vertical frequency; example 75 Hz). After setting the tim...

Adjusting the Screen Image Use the buttons on the front control panel to display and adjust the OnView ® controls which display on the screen. The OnView controls are explained at the top of the next page and are defined in “Main Menu Controls” on page 9. Front Control Panel shown below in detail Ma...

Do the following to adjust the screen image: 1 To display the Main Menu, press button [1]. NOTE: All OnView menus and adjustment screens disappear automatically after about 30 seconds. 2 To select a control you want to adjust, press ▲ or ▼ to scroll up or down the Main Menu. 3 After the control is s...

Main Menu Controls Adjust the menu items shown below by using the up ▲ and down ▼ buttons. Control Explanation Auto Image Adjust automatically sizes, centers, and fine tunes the video signal to eliminate waviness and distortion.Press the [2] button to obtain a sharper image.NOTE: Auto Image Adjust w...

Color Adjust provides several color adjustment modes: preset color temperatures and RGB which allows you to adjust red ( R ), green ( G ), and blue ( B ) separately. The factory setting for this product is 6500K (6500 Kelvin). 9300K — Adds blue to the screen image for cooler white (used in most offi...

Other Information 1 Macintosh computers older than G3 require a ViewSonic ® , Macintosh adapter. To order an adapter, contact ViewSonic. Specifications LCD Type Color FilterGlass surface 19" (full 19" viewable diagonal area), TFT (Thin Film Transistor), Active Matrix SXGA LCD, 0.294 mm pixel...

Troubleshooting No power • Make sure power button (or switch) is ON. • Make sure A/C power cord is securely connected to the LCD display . • Plug another electrical device (like a radio) into the power outlet to verify that the outlet is supplying proper voltage. Power is ON but no screen image • Ma...

ViewSonic VX900 15 Customer Support For technical support or product service, see the table below or contact your reseller. NOTE: You will need the product serial number. Country/Region Web site T = TelephoneF = FAX Email United States Canada suppor t suppor t T: (800) 688-6688 F: (909) 468-1202 T: ...

Cleaning the LCD Display • MAKE SURE THE LCD DISPLAY IS TURNED OFF. • NEVER SPRAY OR POUR ANY LIQUID DIRECTLY ONTO THE SCREEN OR CASE. To clean the screen: 1 Wipe the screen with a clean, soft, lint-free cloth. This removes dust and other particles. 2 If still not clean, apply a small amount of non-...

Limited Warranty VIEWSONIC LCD DISPLAY What the warranty covers: ViewSonic ® warrants its products to be free from defects in material and workmanship during the warranty period. If a product proves to be defective in material or workmanship during the warranty period, ViewSonic will, at its sole op...

Appendix Safety Guidelines CAUTION: The socket-outlet should be installed near the equipment and should be easily accessible. CAUTION: Use a power cable that is properly grounded. Always use the appropriate AC cord that is cer tified for the individual country. Some examples are listed below: IMPORT...

Compliance Information for U.S.A. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to par t 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi-dential installation. This equip...