Page 2 - CONTENTS
CONTENTS I .Safety Precautions ---------------------------------------------------------1 II .Product Structure -----------------------------------------------------------2 III .Introduction of Operation Panel and Function -------------------------3 IV .Sanitary and Parts Cleaning of Ice Cream Machi...
Page 3 - Safety Precautions
1 Safety Precautions I . The Unpacking and Inspection of New Machines 1 ） Cut and unpack the straps and planks that secure the carton; Remove the carton and foam board ,and remove the bag to see if the machine is damaged; ( Note: The machine must not be tilted more than 45° during handling) 2 ） Open...
Page 4 - Product Structure
2 +6% 380V -10% （ 342V-403V ） 3 ） Look at the nameplate attached to the rear panel of the machine, to check if the voltage specified on the machine matches the local power supply voltage. 4 ） Be sure to entrust the electrical construction agency to connect the ground wire. Otherwise, an electric sho...
Page 5 - Operation Panel and Function Introduction
3 Operation Panel and Function Introduction The operation panel is divided into an LCD screen and a touch screen (select the corresponding operation by physical comparison) LCD screen operation and function introduction 1 ） Cleaning/Defrosting Button ： In the standby state, the button is clicked to ...
Page 8 - Ice Cream Manufacturing Method
6 Note : Make sure the control power switch is off when you are assembling the machine. Figure F Ice Cream Manufacturing Method 1) Place the prepared ice cream slurry for 15 minutes and pour it into the two tanks at the top of the ice cream machine; Note:Requires slurry not to agglomerate. 2) Turn o...
Page 9 - Ice Cream Machine Cleaning and Maintenance Methods
7 8) After the cooling is completed, the hardness of the ice cream is too hard to make the display alarm or the freezing cylinder does not stir, no discharge phenomenon. If so, first cut off the power switch, press the switch again after 30 seconds, and press the “Thaw” button to freeze Thaw in the ...
Page 10 - Annex; Seal O Ring 1 set Scraper 2 Pieces Cleaning Brushes 1 Set; Fault Analysis and Solutions
8 tank of the machine. If the drain pipe has liquid such as raw materials, it may be caused by a defective motor shaft in the deep part of the freezing cylinder, so please contact the store or maintenance personnel. Note: Please do not use polishing powder, gasoline, hot water, etc., otherwise it wi...
Page 12 - Technical Parameters:
10 Technical Parameters: Specific technical parameters and refrigerant performance are subject to the nameplate. not stop. 12 When the ice cream is made, themotor does notwork, and the icecream does notcome out. 1.Travel switch is damaged. 1.Repair or replace the travelswitch. 13 Beater Split Under ...
Page 13 - to the actual product!
11 The pictures in the manual are for illustrative purposes only, please refer to the actual product!
