Uniden UH060SX-2 - Manuals - manualsarea.com

Page 2 - INCLUDED IN YOUR PACKAGE:; Operating Guide; OPTIONAL ACCESSORIES; VOX Earset

vo l/c h 2 CONTROL & INDICATORS INCLUDED IN YOUR PACKAGE: • UH060SX Radio (2) • Operating Guide • Belt Clip (2) OPTIONAL ACCESSORIES • VOX Earset • Carry Case 1 Antenna2 PTT (Push-To-Talk) Button3 Monitor Button4 Duplex/Call Key5 Scan Key6 Channel/Volume/Keylock Key7 Speaker8 Headset Jack9 Volum...

Page 3 - GETTING STARTED; BATTERY INSTALLATION; To install the batteries:; remove the battery cover.

3 GETTING STARTED BATTERY INSTALLATION Your UH060SX-2 unit uses the included NiMH battery pack forpower. The unit can be powered with optional 4 AAA ALKALINEbatteries. To avoid damage to the unit do not mix old andnew batteries. Do not charge alkaline or non rechargeablebatteries. Uniden does not re...

Page 4 - To attach the belt clip:; Slide the belt clip until it snaps into place.; To remove the belt clip:; INSTALLING THE CHARGE CRADLE

4 Place the UH060SX-2 into the charge cradle. The charge light willcome on to indicate the unit is charging. Before operating theUH060SX-2, charge the battery pack for 16 hours. If the battery level becomes low, the batteryindicator icon on the display begins flashing. When the batteries in the unit...

Page 5 - OPERATION; VOLUME; ‘VOL’; ADJUSTING THE KEY BEEPS

5 OPERATION POWER ON/OFF Press and hold select/power key to turn the radio on. A channel number will appear on thedisplay. Press and hold select/power key to turn the radio off. VOLUME Press volume/channel ▲ or ▼ key to increase or decrease the volume level. ‘VOL’ icon appears on the display while v...

Page 6 - ‘TX’

6 SELECTING A CHANNEL • Press ch/vol/keylock key momentarily to activate channel select mode. Thedisplayed channel will flash. • Press volume/channel ▲ or ▼ key to select the desired channel. • Press ch/vol/keylock key momentarily to exit channel select mode. • If no button is pressed within 4 sec t...

Page 7 - ‘RX’; ‘RX’; moni; ‘RX’; TRANSMIT Hi/Lo POWER SELECT; ‘HI’

7 AUTOMATIC SQUELCH FEATURE The UH060SX-2 is equipped with an Automatic Squelch Systemwhich shuts off weak transmissions and unwanted noise. MONITOR This feature enables users to listen for weaksignals on the current channel at the press of abutton. To use monitor: • Press moni button. The ‘RX’ icon...

Page 8 - If

8 TO OPERATE IN DUPLEX MODE (REPEATERS) The Duplex function enables you to access local repeaterstations. You can only activate Duplex from CH01-CH08. UHF CB Repeaters are used to retransmit or relay your signal.Repeaters will extend the range of your radio and overcome theshielding effect caused by...

Page 9 - REPLY DELAY; To initiate scanning,; ‘SCAN’; scan; CTCSS

REPLY DELAY While scanning, the UH060SX-2 stops at abusy channel and receives a transmission.When the received signal is over, the unitwill wait for 2 seconds for the return of thesignal, otherwise, the radio resumes scanning. To initiate scanning, 1. Press scan key momentarily to begin scanning. Th...

Page 10 - TRANSMITTING A CALL TONE; ‘oF’

10 TRANSMITTING A CALL TONE Your UH060SX-2 radio is equipped with 5 selectable call tonesthat will be transmitted when the dup/call key is pressed and held for 3 seconds.To select a call tone:1. Press select/power key momentaly twice while in standby mode to enter Call Tone mode. The current call to...

Page 11 - UHF CHANNELS & FREQUENCIES

11 UHF CHANNELS & FREQUENCIES Simplex Mode Duplex Mode Simplex Mode CH No. Transmit / Receive Transmit CH No. Transmit / Receive Frequency (MHz) Frequency (MHz) Frequency (MHz) 1 476.425 477.175 CH31 21 476.925 2 476.450 477.200 CH32 22 476.950 3 476.475 477.225 CH33 23 476.975 4 476.500 477.250...

Page 12 - WARRANTY; UNIDEN UH060SX-2 UHF CB RADIO

WARRANTY Please keep your sales docket as it provides evidence of warranty. UNIDEN UH060SX-2 UHF CB RADIO Limited One Year Warranty Warrantor: Uniden Australia Pty Limited ABN58 001 865 498 Uniden New Zealand Limited. Warranty only available in original country of purchase Elements of Warranty: Unid...