Page 2 - INCLUDED IN YOUR PACKAGE:; OPTIONAL ACCESSORIES
CONTROL & INDICATORS 1 Antenna 2 PTT (Push-To-Talk) Button 3 Channel/scan up Key 4 Channel/scan down Key 5 Duplex/Transmit Hi/Lo 6 Speaker 7 Power On/Off/Select Key 8 Monitor Key 9 Volume up Key 10 Volume down Key 11 Battery Compartment Door 1 INCLUDED IN YOUR PACKAGE: ! ! ! ! ! UH039P Radio (2)...
Page 3 - GETTING STARTED; BATTERY INSTALLATION; Plug the AC adaptor into the rear of the charge cradle and
Your UH039P unit uses the included NiMH battery pack for power. The unit can be powered with optional 4 AAA ALKALINE batteries. GETTING STARTED To avoid damage to the unit do not mix old and new batteries. To install the batteries:1. Make sure your radio is off.2. Remove the battery compartment door...
Page 4 - LOW BATTERY ALERT; To attach the belt clip:; BELT CLIP; Do not charge alkaline or non
If the battery level becomes low, the battery indicator icon on the LCD begins flashing. LOW BATTERY ALERT When the batteries in the unit are low, the unit will go into a Battery Low mode. The Transmit mode is disabled. Replace the alkaline batteries immediately or if you are using the NiMH battery ...
Page 5 - OPERATION; VOLUME; ROGER BEEP; To turn
OPERATION 4 volume channel/ scan dup mon VOL hi/lo VOLUME Press volume or to increase or decrease the volume level. icon appears on the display while volume is being adjusted. There are 8 volume levels. Level 0 (No Audio) to Level 7 (Maximum Volume). 'VOL' POWER ON/OFF Press and hold to turn the rad...
Page 6 - Hold the radio with microphone approximately 5 cm in
SELECTING CHANNEL Press channel/scan or to select the desired channel. TO TRANSMIT AND RECEIVE The uses the 40 UHF-CB Channels. For your reference a list of the available channels and corresponding frequencies is printed on page 10. UH039P 1. Before you transmit, listen for activity on the selected ...
Page 7 - MONITOR
6 AUTOMATIC SQUELCH FEATURE The is equipped with an Automatic Squelch System which shuts off weak transmissions and unwanted noise. UH039P TRANSMIT Hi/Lo SELECT ! ! ! Press and hold for 2 seconds when the unit is in Transmit Lo and it will switch to Transmit Hi. icon will appear on display. Press an...
Page 8 - If; Operation with the aid of a Repeater; Contact your retailer for a list of repeaters
7 DUP dup dup dup Press momentarily. The icon appears. Press again to deactivate the duplex operation. will return to normal operation. 'DUP' UH039P If is pressed when the channel is not from CH01 - CH08, an error tone sounds. TO OPERATE IN DUPLEX MODE (REPEATERS) The Duplex function enables you to ...
Page 9 - CTCSS; Scan; or
8 Channels 5 and 35 are used for emergency channels. CTCSS will not operate on these channels. CTCSS (Continuous Tone Coded Squelch System) CTCSS is a feature that allows a group to talk to each other without hearing other users on the same channel. Press momentarily in Stand By mode to enter CTCSS ...
Page 10 - While in Keylock on mode, the UH039P will still
REPLY DELAY While scanning, the stops at a busy channel and receives a transmission. When the received signal is over, the unit will wait for 2 seconds for the return of the signal, otherwise, the radio resumes scanning. The flashes during the Setting mode. Press channel/scan or to select or is show...
Page 11 - UHF CHANNELS & FREQUENCIES
UHF CHANNELS & FREQUENCIES 10 476.425 476.450 476.475 476.500 476.525 476.550 476.575 476.600 476.625 476.650 476.675 476.700 476.725 476.750 476.775 476.800 476.825 476.850 476.875 476.900 Simplex Mode Transmit / Receive Frequency (MHz) Duplex Mode Transmit Frequency (MHz) 477.175 CH31 477.200 ...
Page 12 - Limited One Year Warranty; WARRANTY
UNIDEN UHF CB RADIO UH039P Limited One Year Warranty Please keep your sales docket as it provides evidence of warranty. Warrantor: Elements of Warranty: Warranty Duration: Parts Covered: Statement of Remedy: Procedure for Obtaining Performance or Warranty: UNIDEN AUSTRALIA PTY LIMITED Uniden Austral...