Page 2 - Important Safety Instructions!; SAVE THESE INSTRUCTIONS!; tti; Important Informa
Important Safety Instructions! When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: y Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sin...
Page 3 - Install the Ba; Charge the handset completely (about 15 hours) before using it.
3 Se tti ng Up Your Handset Install the Ba tt ery 1. Unpack the handset, battery pack, and battery cover. If the battery cover is already on the handset, press in on the notch and slide the cover down and off. 2. Line up the battery pack connector with the jack inside the handset. (The battery conne...
Page 4 - Registering the Handset; charger. You can use the handset normally even; Compa; Handset Registering; when the phone is in; After about 30 seconds, the handset display should say; Registration Complete
4 Registering the Handset # Registering the handset is a separate process from registering the MULTIRANGE TM charger. You can use the handset normally even if the charger is not registered. # The accessory handset will not work until you register it to a base! Compa ti ble Bases This handset is desi...
Page 5 - you don't hear a dial tone; Using the Handset; Compatible Bases
5 Test the connec ti on Pick up the handset and press TALK . Make sure you get a dial tone. (Press END to hang up.) If... Try... - you don't hear a dial tone - the display says Registration Failed Making sure the handset is fully charged, then trying again. Using the Handset y When the handset regis...
Page 6 - Using the MULTIRANGE; Charger; How It Works; The DRX332 MULTIRANGE; charger extends the range of your
6 Using the MULTIRANGE TM Charger How It Works The DRX332 MULTIRANGE TM charger extends the range of your base in all directions, including up and down. Each handset will automatically connect to the charger or the base, depending on which signal is stronger. (The handset operates exactly the same w...
Page 7 - Registering the MULTIRANGE charger
7 y Each of these bases can support up to two DRX332 MULTIRANGE chargers, including any that were supplied with your phone. y Usually, you can't tell when a handset switches between the base and the charger in the middle of a call, but sometimes, you might notice a brief pause in your conversation. ...
Page 8 - Placing the MULTIRANGE charger; at least 35 feet; Picking the best spot
8 Some important things to remember: y Only register one charger at a time. If more than one charger is in registration mode at the same time, they can interfere with each other. y If you want to use the MULTIRANGE charger with a different base, just register the charger to the new base. The charger...
Page 10 - Speci
10 Important Informa ti on Speci fi cations AC Adapter Part number PS-0033 Input voltage 120V AC, 60 Hz Output voltage 6.5V AC @ 350mA Battery pack Part number BT-1018 Capacity 500mAh, 2.4V DC y Use only the supplied AC adapter. y Be sure to use the proper adapter for the base and any chargers. y Do...
Page 12 - Compliance Information; FCC Part 15 information
12 Compliance Information Any changes or modi fi ca ti ons to this product not expressly approved by the manufacturer or other party responsible for compliance could void your authority to operate this product. FCC Part 15 information This device complies with part 15 of the FCC rules. Opera ti on i...
Page 13 - RF exposure information; Terminal equipment
13 RF exposure information This product complies with FCC radia ti on exposure limits under the following condi ti ons: • The base must be placed to allow a minimum of 20 cm (8 inches) between the antenna and all persons during normal opera ti on. • The base must not be collocated or operated in con...
Page 14 - One-year Limited Warranty
14 Radio equipment The term IC before the radio cer ti fi ca ti on number only signi fi es that Industry Canada technical speci fi ca ti ons were met. Opera ti on is subject to the following two condi ti ons: (1) this device may not cause interference, and (2) this device must accept any interferenc...