Tyan TYAN S1572 ATX - Manuals

Page 2 - ( Declaration of Comformity Procedure) DoC; Reorient or relocate the receiving antenna.

2 S1572-001-01 http://www.tyan.com Notice for the USACompliance Information Statement ( Declaration of Comformity Procedure) DoC FCC Part 15: This Device complies with Part 15 of the FCC Rules.Operation is subject to the following conditions:1) this device may not cause harmful interference, and2) t...

Page 3 - Table Of Contents

3 S1572-001-01 http://www.tyan.com Table Of Contents 1. Introduction....................................................................... 3 1.1 Overview................................................................31.2 Hardware Specifications.......................................... 41.3 Softwa...

Page 4 - Notice

4 S1572-001-01 http://www.tyan.com 1. Introduction 1.1 Overview The S1572 is a quality, high performance mainboard designed for IntelPentium microprocessors. This mainboard utilizes the Intel 430TX chipsetand can support CPU speeds of 75MHz through 200MHz. The S1572will also support the CyrixM1/6x86...

Page 6 - Software Specifications; Trademarks

6 S1572-001-01 http://www.tyan.com 1.3 Software Specifications w BIOS Award or AMI BIOS AT CMOS setup, BIOS/CHIPSET setup,and hard disk utility included.Support for easy BIOS upgrades with flashEPROM chip. w O.S. Operates with MS-DOS, Windows 3.x, Windowsfor Work Group 3.x, Windows 95, Windows NTOS/...

Page 7 - Board Installation; The mainboard package should contain the following:

7 S1572-001-01 http://www.tyan.com 2. Board Installation 2.1 Unpacking The mainboard package should contain the following: w S1572 Mainboard w One IDE 40 pin cable w One 34 pin floppy cable w User's Manual The mainboard contains sensitive electric components which can be easilydamaged by static elec...

Page 8 - Socket 7; Tag RAM

8 S1572-001-01 http://www.tyan.com Parallel Port PCI Slot 1 PCI Slot 2 PCI Slot 3 PCI Slot 4 PCI Slot 5 ISA Slot 1 ISA Slot 2 ISA Slot 3 3. On Board Resource SettingFigure 3.1 S1572 ATX Board Layout PS/2Mouse PS/2KB Socket 7 CPU 0 SRAM SRAM ATX PWR CON DRAM Bank 2 SDRAM Bank 0 DRAM Bank 2DRAM Bank 1...

Page 11 - Keylock Connector: J25

11 S1572-001-01 http://www.tyan.com Reset Connector: J8 pin 22-23 Pinout Assignment22 Power Good 23 Ground Flash EPROM: JP2 This jumper should be left at the factory default. JP2 1-2 Keylock Connector: J25 Pinout Assignments1 Led 2 No Connect 3 Ground 4 Keylock 5 Ground

Page 14 - Refer to chapter 5 for Flash EPROM upgrade procedures.; Hardware CMOS & Password Reset; a. Power off the system

14 S1572-001-01 http://www.tyan.com Refer to chapter 5 for Flash EPROM upgrade procedures. 3.9 Hardware CMOS & Password Reset If you have been locked out of your system because you forgot your pass-word or set the CMOS incorrectly, follow the instructions below. a. Power off the system b. Jumper...

Page 15 - DRAM Installation

15 S1572-001-01 http://www.tyan.com 3.10 DRAM Installation The S1572 uses a 64-bit data path from memory to CPU and canaccommodate up to 256MB of RAM. The mainboard supports Fast PageMode, and EDO (Extended Data Out) 72 pin SIMMs.SDRAM(Synchronous) are also supported in the DIMM slots. DIMM'smust be...

Page 16 - CPU Installation; The CPU is a sensitive electronic component and it can be easily; A cooling fan and heat sink assembly is required to protect the

16 S1572-001-01 http://www.tyan.com 1. Make sure the ZIF socket lever is up. To raise the lever, pull it out to the side a little and raise it as far as it will go. The top plate will slide back. 2. Align the CPU and socket Pin 1 corners. The pins on the bottom should align with the rows of holes in...

Page 17 - Upgrading Cache Memory; The S1572's 512kb of on-board pipelined burst SRAM and cannot be; Peripheral Device Installation

17 S1572-001-01 http://www.tyan.com 3.12 Upgrading Cache Memory The S1572's 512kb of on-board pipelined burst SRAM and cannot be field upgraded. The TX chipset can cache a maximium of 64MB ofRAM. 3.13 Peripheral Device Installation After all the jumpers on the mainboard have been set, then it can be...

Page 18 - BIOS Configuration; Entering incorrect information or for-

18 S1572-001-01 http://www.tyan.com 4. BIOS Configuration Award's BIOS has a built in setup program that allows the user to modifythe basic system configuration. This type of information is stored in thebattery-backed CMOS NVRAM. Entering incorrect information or for- getting your password can lock ...

Page 20 - CMOS SETUP UTILITY

20 S1572-001-01 http://www.tyan.com 4.3. Getting Help 4.3.1. Main Menu The on-line description of the highlighted setup function is displayed at thebottom of the screen. 4.3.2. Setup Page menu/Option Page Setup Menu Press F1 to pop up a small help window that describes the appropriate keysto use and...

Page 22 - STANDARD CMOS SETUP

22 S1572-001-01 http://www.tyan.com w Date The date format is <month>, <day>, <year>. Press <F3> to show the calendar. Base Memory: 640 K Extended Memory: 7168 KExpanded Memory: 0 KOther Memory: 384 K Total Memory: 8192 K ESC: Quit : Select Item PU/PD/+/-: M o d i f y F1: Hel...

Page 23 - Drive A type/Drive B type

23 S1572-001-01 http://www.tyan.com None No floppy drive installed 360K, 5.25 in. 5-1/4 inch PC-type standard drive; 360 kilobyte capacity 1.2M,5.25 in. 5-1/4 inch AT-type high-density drive; 1.2 megabyte capacity 720K, 3.5 in. 3-1/2 inch double-sided drive; 720 kilobyte capacity 1.44M, 3.5 in. 3-1/...

Page 24 - Video; Color Graphics Adapter, power up in 40 column mode.; Halt On; Base Memory

24 S1572-001-01 http://www.tyan.com w Video This category detects the type of graphics adapter used for the primarydisplay system. It must match your video display card and monitor. Al-though secondary monitors are supported, you do not have to select thattype in setup. EGA/VGA Enhanced Graphics Ada...

Page 25 - ROM ISA BIOS

25 S1572-001-01 http://www.tyan.com Expanded Memory Expanded Memory (EMS) defines a 64K page frame inthe area between 640K and 1Mb containing four 16K pagesthat are windows into the EMS memory. Programs issuerequests to the EMS manager to switch the page to anypart of EMS memory. Extended memory can...

Page 26 - Default value is Disabled

26 S1572-001-01 http://www.tyan.com w Virus warning This category flashes on screen. During and after the system boot up, any attempt to write to the boot sector or the partition table of the hard disk drive will halt the system and the following error message will appear. In the meantime, you can r...

Page 27 - Default value is On; Gate A20 Option

27 S1572-001-01 http://www.tyan.com w Boot Up Floppy Seek During POST, the BIOS will determine if the floppy disk drive installed is 40 or 80 tracks. 360K type is 40 tracks while 720K, 1.2M and 1.44M are all 80 tracks. Default value is Enabled Enabled BIOS searches for floppy disk drive to determine...

Page 28 - Chipset Features Setup; The Chipset Features Screen; Security Option

28 S1572-001-01 http://www.tyan.com ROM ISA BIOS CHIPSET SETUP UTILITY AWARD SOFTWARE, INC. Auto Configuration :Enabled DRAM Timing :70ns DRAM Leadoff Timing :10/6/3 DRAM Readburst (EDO/FP) :x222/x333DRAM Write Burst Timing : x 3 3 3 Fast EDO Path Select :Disabled Refresh RAS# Assertion :5/Clks Fast...

Page 31 - PCI Slot Configuration

31 S1572-001-01 http://www.tyan.com 4.8 PCI Slot Configuration ROM ISA BIOS PCI SLOT CONFIGURATION AWARD SOFTWARE, INC. Resource Controlled by :Manual Reset Configuration :Disabled IRQ3 assigned to :legacy ISA IRQ4 assigned to :legacy ISA IRQ5 assigned to : P C I / P n P IRQ7 assigned to :legacy ISA...

Page 32 - Devices compliant with the original PC AT bus specification.; PCI IRQ Activated By:; Default value is LEVEL.

32 S1572-001-01 http://www.tyan.com w Resources Controlled By The Award Plug and Play BIOS can automatically configure all the boot and Plug and Play compatible devices. If you select Auto, all the interrupt request and DMA assignment fields disappear, as the BIOS automatically assigns them. w IRQ n...

Page 33 - Integrated Peripherals

33 S1572-001-01 http://www.tyan.com 4.9 Integrated Peripherals Integrated Peripherals Award Software, Inc. IDE HDD Block Mode :Enabled IDE Primary Master PIO :Auto IDE Primary Slave PIO :Auto IDE Secondary Master PIO :Auto IDE Secondary Slave PIO :Auto IDE Primary Master UDMA :Auto IDE Primary Slave...

Page 34 - Load SETUP defaults; If any problem has occurred, loading the SETUP DEFAULTS is

34 S1572-001-01 http://www.tyan.com STANDARD CMOS SETUP PASSWORD SETTING BIOS FEATURES SETUP IDE HDD AUTO DETECTION CHIPSET FEATURES SETUP DAVE & EXIT SETUP PCI SLOT configuration EXIT WITH OUT SAVING LOAD SETUP DEFAULTS 4.10. LOAD SETUP DEFAULTS ROM ISA BIOS CMOS SETUP UTILITY AWARD SOFTWARE IN...

Page 37 - Flash Writer Utility; AMIFLASH.COM -The Flash Memory Writer utility for; Note

37 S1572-001-01 http://www.tyan.com 5.0 Flash Writer Utility You can upgrade the BIOS of your mainboard by using a "FlashMemory Writer"(FMW) utility. This utility can be downloaded from thefactory's BBS(Consult your system vendor for the phone #). Thesystem BIOS is stored on a 'flash' EPROM ...

Page 39 - Once you have satisfied the two requirements mentioned above,; If you do not successfully install a complete BIOS file

39 S1572-001-01 http://www.tyan.com Once you have satisfied the two requirements mentioned above, you can run FMW. You can copy the contents of the “Flash”directory to your hard drive, or you can run the utility from abackup of the support floppy disk. Make sure the new BIOS fileis in the same direc...

Page 40 - Parity check error

40 S1572-001-01 http://www.tyan.com 6.0 System Resource6.1. TIMER & DMA CHANNEL MAP TIMER MAP: TIMER Channel-0 system timer interruptTIMER Channel-1 DRAM REFRESH requestTIMER Channel-2 SPEAKER tone generator DMA CHANNELS: DMA Channel-0 AvailableDMA Channel-1 AvailableDMA Channel-2 FLOPPY DISK ad...