Page 2 - TABLE OF CONTENTS
TABLE OF CONTENTS The serial tag is a permanently affixed label on which is recorded vital electrical and refrigeration data about your Traulsen product, as well as the model and serial number. This tag is located in the right interior compart- ment on all standard full-size undercounter models. I. ...
Page 3 - II. RECEIPT INSPECTION
-2- II. RECEIPT INSPECTION All Traulsen products are factory tested for performance and are free from defects when shipped. The utmost care has been taken in crating this product to protect against damage in transit. You should carefully inspect your unit for damage during delivery. If damage is det...
Page 5 - VI. a - REMOVING THE DOOR AND INSTALLING
-4- V. b - REPLACING THE GASKETS: To remove the gasket to be replaced, grasp it firmly by one corner and pull it out. Before attempting to install a new gasket, both the unit and the gasket itself must be at room temperature. Insert the four corners first by using a rubber mallet (or hammer with a b...
Page 6 - All microprocessor control equipped models are capable of com-; Display Features; • 3-Digit LED Display; MICROPROCESSOR CONTROL
-5- VII. MICROPROCESSOR CONTROL Your new refrigerator or freezer cabinet is equipped with a state-of-the-art microprocessor control, which precisely regulates operation and provides alarms when problems occur. It is supplied from the factory completely ready for use and requires no adjustments, but ...
Page 8 - ALARM CANCEL BUTTON
-7- VII. MICROPROCESSOR CONTROL (continued) VII. c - CONTROL PANEL DIAGRAM: VII. d - NOTES TO THE USER: You only have 20-30 seconds between button pushes. If you take longer than 30 seconds, the controller will revert back to displaying the cabinet temperature. If you enter the wrong security code, ...
Page 10 - sor; SET
VII. g - ADJUSTING THERMOSTAT SET POINT HIGH: This parameter sets the high point of the desired cabinet temperature range. Typically, freezers will range from -3° F to 0° F (-19° C to –18° C) and refrigerators will range from 36° F to 40° F (2° C to 4° C) for this parameter setting. This parameter i...
Page 14 - DEFROST ICON
This parameter allows a service technician to start a defrost cycle at any time. This parameter will override any lock-out settings. Follow the instructions to enter the customer access code on page 8. When the control displays Thermostat Set High, press the down arrow key until the control display ...
Page 18 - VIII. WIRING DIAGRAM; by a qualified technician.
-17- VIII. WIRING DIAGRAM Note: Refer to the wiring diagram below (applies to refrigerators and freezers units) for any service work performed by a qualified technician.
Page 19 - IX. TROUBLE SHOOTING GUIDE
PROBLEM POSSIBLE SOLUTION 1. Condensing unit fails to start. a. Check if cord & plug has been disconnected. b. Clean Condenser 2. Condensing unit operates for prolonged periods or continuously. a. Are doors closed properly? b. Dirty condenser or filter. Clean properly. c. Evaporator coils iced. ...
Page 20 - X. SERVICE ASSISTANCE
-19- X. SERVICE ASSISTANCE X. a - SERVICE INFORMATION: Before calling for service, please check the following: Is the electrical cord plugged in? Is the fuse OK or circuit breaker on? Clean condenser coil Is the power switch on? Reset microprocessor control values to factory defaults. If after check...
Page 22 - XII. SERVICE PARTS LIST
-21- XII. SERVICE PARTS LIST ITEM DESCRIPTION PART NUMBER CASTER ALL MODELS 6” ADJUSTABLE CASTER NO LOCK SER-60538-00 6” ADJUSTABLE CASTER WITH LOCK SER-60538-01 LEG ALL MODELS 6” LEG SER-60542-00 DOOR ALL MODELS DOOR ASSEMBLY, HINGED LEFT 200-60593-00 DOOR ASSEMBLY, HINGED RIGHT 200-60593-01 DOOR G...
Page 24 - Quality Refrigeration; raulsen
HOURS OF OPERATION: Monday thru Friday 7:30 am - 4:30 pm CST Quality Refrigeration © 2008 Traulsen - All Rights Reserved T raulsen 4401 Blue Moud Road Fort Worth, TX 76106 Phone (800) 825-8220 Fax (817) 740-6757 Website: www.traulsen.com