Page 3 - CE Mark Warning; SAFETY NOTICES
CE Mark Warning This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. SAFETY NOTICES Cautions Do not use this product near water, for example, in a wet basement or near a swimming pool. Avoid...
Page 4 - Package Contents
Package Contents The following items should be found in your box: ¾ One TL-SF1005D/TL-SF1008D/TL-SF1016D Switch ¾ One Power Adapter ¾ This User Guide ) Note: Make sure that the box contains the above items. If any of the listed items are damaged or missing, please contact with your distributor.
Page 5 - CONTENTS
CONTENTS Chapter 1. Introduction of the Product................................................................... 1 1.1 Overview of the Product ............................................................................ 1 1.2 Convention ................................................................
Page 6 - Chapter 1. Introduction of the Product; the
1 Chapter 1. Introduction of the Product Thank you for choosing the TL-SF1005D/TL-SF1008D/TL-SF1016D 10/100Mbps Desktop Switch. 1.1 Overview of the Product TL-SF1005D/TL-SF1008D/TL-SF1016D 10/100Mbps Desktop Switch provides 5/8/16 10/100Mbps Auto-Negotiation RJ45 ports. All ports support Auto MDI/MD...
Page 7 - Chapter 2. Installation; Mounting the Switch on a Desk
2 ¾ Plastic case, desktop or wall-mounting design ¾ External Power Adapter supply Chapter 2. Installation 2.1 Mounting the Switch on a Desk To install the Switch, please follow the steps: 1) You can place the Switch on a flat desk. 2) Please inspect the Power Adapter carefully and make sure that it ...
Page 8 - Chapter 3. Identifying External Components
Chapter 3. Identifying External Components This Chapter describes the front panel, rear panel and LED indicators of the Switch. 3.1 Front Panel Figure 3-1 TL-SF1016D Switch Front Panel The Switch’s LEDs are located on the front panel. ¾ Power LED: This indicator will light up when the Switch powers ...
Page 9 - Appendix A: Specifications
4 Appendix A: Specifications General Standards IEEE802.3 10Base-T, IEEE802.3u 100Base-TX Topology Star Protocol CSMA/CD Ethernet: 10Mbps (Half Duplex), 20Mbps (Full Duplex) Data Transfer Rate Fast Ethernet: 100Mbps (Half Duplex), 200Mbps (Full Duplex) 10Base-T: UTP category 3, 4, 5 cable (maximum 10...
Page 10 - Appendix B: Troubleshooting
5 Appendix B: Troubleshooting 1. The Power LED is not lit Check to see if the power cord is connected to the Switch properly, and make sure the power source is ON. 2. The Link/Act LED is not lit when a device is connected to the corresponding port Check to see if the cable connectors are firmly plug...