Toshiba SD-M1401 - Manuals - manualsarea.com

Page 2 - CONTENTS

CONTENTS Introduction.............................................................................. 1 Setup ........................................................................................ 3 Using the DVD-ROM Drive ...................................................... 7 Troubleshooting........

Page 3 - General Features; Types of Disc Formats Supported

1 INTRODUCTION – SD-M1401 DVD-ROM Drive General Features Tray Loading Mechanism 3-way Disc Eject (eject button, software, emergency eject hole) Average Random Access Time CD-ROM 85ms DVD 105ms DAE (Digital Audio Extraction) Audio Capability MPC3 Compatibility Headphone Output Volume Control Multi-Re...

Page 4 - CD; Front Panel; Load disc using tray.; Busy Indicator; BUSY light flashes slowly. The disc may be dirty.

CD • CD-DA • CD+(E)G • CD-MIDI • CD-TEXT • CD-ROM • CD-ROM-XA • CD-I Bridge (Photo-CD, Video CD) • CD-I • Multi-session (Photo-CD, CD Extra, CD-RW, CD-R) • CD-R (Read) • CD-RW (Read) Front Panel Figure 1.SD-M1401 DVD-ROM Drive Front Panel Loading Tray Load disc using tray. Busy Indicator When you in...

Page 5 - Jumper Settings; Figure 1. Jumper Location; Figure 2. Jumper Block; Figure 3. SCSI ID Examples; Parity

3 SETUP – SD-M1401 DVD-ROM The following steps must be performed to properly install your drive: • Set DVD-ROM Drive Jumper Settings: SCSI ID, Parity, Termination, 512/2K, Power • Connect Audio Cable • Attach SCSI Interface Cable • Attach Power Cable • Daisy-Chaining SCSI Drives (if applicable) • Mo...

Page 6 - Placing DVD-ROM Drive inside your Computer; SCSI Interface Cable (not supplied with drive)

4 Terminator ON/OFF - This jumper turns termination power ON or OFF. If you are connecting more than one SCSI device to your system, and the DVD-ROM is not at the end of the chain, then terminator jumper is not required. 512/2K (Block Size Selectability) - This jumper is used to select default block...

Page 8 - Completing Installation; Figure 7.Mounting Illustration

6 Completing Installation After you have connected all the necessary cables, push the DVD-ROM drive completely into the computers drive slot. Mount drive per your computers instructions. The screw length should not exceed 30.5mm (measured from outside surface of side or bottom of drive to tip of scr...

Page 9 - Figure 1.Inserting Disc; Inserting a Disc - Vertically; Position the disc behind the disc holders

7 USING THE DVD DVD-ROM Drive – SD-M1401 Drive Operation Inserting a Disc - Horizontally To insert a disc into a drive that is mounted horizontally, perform the following steps: Figure 1.Inserting Disc 1. Open the drive's Loading tray by pressing the Eject Button. 2. Place disc into drive's Loading ...

Page 10 - Figure 3.Using Emergency Eject

8 Removing a Disc To remove a disc from the DVD-ROM drive, perform the following steps: 1. Open the Loading Tray by pressing the Eject Button. 2. Grasp disc by edges, and lift out of loading tray. 3. Press Eject Button again to close Loading Tray. Usage Guidelines • Keep the disc tray closed when no...

Page 11 - Handling Media

9 Handling Media DVD media is sensitive to dust and fingerprints. Carefully handle media by its edges only. If a DVD movie skips or hangs during playback, clean the media. Most DVD video playback issues are media-related and can be remedied by proper handling and care of media. Cleaning Media Try to...

Page 12 - TROUBLESHOOTING – SD-M1401; Problem; Solution; Disc tray cannot be opened

10 TROUBLESHOOTING – SD-M1401 Problem Solution Disc tray cannot be opened • Check that there is power to drive. • Use Emergency Eject instructions to open tray. Drive is not recognized by system • Is the drive connected properly? Are all cables plugged in properly (e.g. Power Cable, Interface Cable ...

Page 13 - General; Interface SCSI; Performance; Data Transfer Rate

11 SPECIFICATIONS –SD-M1401 General Interface SCSI Compatible DVD-ROM Standards DVD DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18) DVD-R (Read, Ver 1, 3.9GB media only) CD CD-DA CD-ROM CD-I Bridge (Photo-CD, Video CD) Multi-session (Photo-CD, CD Extra, CD-RW, CD-R) CD-MINI CD-TEXT CD+(E)G CD-ROM-XA CD-I CD-...

Page 16 - DRIVE CONNECTORS –SD-M1401; Supplies Analog sound to your system

14 DRIVE CONNECTORS –SD-M1401 Figure 1.SD-M1401 DVD-ROM Drive Rear Panel - Connectors Power Connector Power is supplied to your DVD-ROM drive by the connection with your computer's +5V/+12V power cable to the power socket at the back of drive. One side of the plug has chamfered edges, so the power c...

Page 17 - Table 1.Interface Pin Assignments; PIN

15 Table 1.Interface Pin Assignments PIN NO. SIGNAL NAME PIN NO SIGNAL NAME 1 GND 2 -DB0 3 GND 4 -DB1 5 GND 6 -DB2 7 GND 8 -DB3 9 GND 10 -DB4 11 GND 12 -DB5 13 GND 14 -DB6 15 GND 16 -DB7 17 GND 18 -DBP 19 GND 20 GND 21 GND 22 GND 23 GND 24 GND 25 NO CONNECTION 26 TERM POWER (+5v) 27 GND 28 GND 29 GN...

Toshiba SD-M1401 - Manuals

Manuals:

Manual Toshiba SD-M1401

Summary

Toshiba Manuals