Page 2 - CONTENTS
CONTENTS Introduction.............................................................................. 1 Setup ........................................................................................ 3 Using the DVD-ROM ................................................................ 4 Troubleshooting....
Page 3 - General Features; ATAPI; Types of Disc Formats Supported –; single; Front Panel
1 INTRODUCTION – SD-C2612 General Features 100ms Average Access Time (DVD) Lead (Pb) Free Printed Circuit Board Multimedia PC-3 Spec Compliant RPC2 Compliant Drawer Type Manual Load/ Electrical Release 8x sampling & digital filter for CD-Audio DVD-RAM, CD-R and CD-RW Compatible Drive Speed DVD 8...
Page 4 - BUSY light flashes slowly. The disc may be dirty.; Emergency; EJECT button is pressed.; DVD Tray; Insert DVD Disc in tray
Eject Button The EJECT button is used to open the disc tray so you can install or remove a disc Busy Indicator When you install a disc into the DVD-ROM drive, the BUSY light flashes slowly as it attempts to locate the disc. One of the following will occur: • BUSY light goes out. The DVD-ROM drive is...
Page 5 - Installation Notes; The SD-C2612 DVD-ROM drive has no jumpers that need to be set; Software Driver
3 SETUP – SD-C2612 Toshiba recommends that only trained professionals install this DVD-ROM drive into your laptop/notebook. Installation Notes • The SD-C2612 DVD-ROM drive has no jumpers that need to be set • Mounting orientation: 15° (horizontally), 15° vertically (volume control in down position),...
Page 6 - Figure 1.Inserting Disc
4 USING THE DVD-ROM Drive – SD-C2612 Drive Operation Inserting Media – Horizontally or Vertically To insert a DVD in a DVD-ROM drive that is mounted horizontally, perform the following steps: Figure 1.Inserting Disc 1. Open the drive's loading tray by pressing the Eject Button and pulling out the tr...
Page 7 - Regional Coding; Emergency Ejection; Turn computer power OFF by properly shutting down system.; Handling Media
5 Regional Coding Region Protection Coding (RPC) of DVD Discs: this feature is supported on DVD Players and is used with DVD-Video Discs (i.e. movies). Currently, the motion picture industry has divided the world into different regional "zones." These regions or "zones" correlate to ...
Page 8 - TROUBLESHOOTING – SD-C2612; Problem; Solution; Disc tray cannot be opened
6 TROUBLESHOOTING – SD-C2612 Problem Solution Disc tray cannot be opened • Check that there is power to drive. • Use Emergency Eject instructions to open tray. Drive is not recognized by system • Is the drive connected properly? Are all cables plugged in properly (e.g. Power Cable, Interface Cable a...
Page 9 - General; Data Disc Capacities; Performance; User Data Blocks
7 SPECIFICATIONS –SD-C2612 General Interface: ATAPI Compatible DVD-ROM Standard - Read : DVD: DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18) DVD-R (ver 1.0 & 2.0, read) DVD-RW (ver 1.1, read) DVD-RAM (ver 1.0 & 2.1, read) CD-ROM: CD-DA, CD+(E)G, CD-MIDI, CD-TEXT, CD-ROM, CD-ROM XA, MIXED MODE CD, CD...
Page 11 - Power; DC Voltage and Current Requirements; Physical; IDE Interface Connector; Regulatory; CE standard
9 Power DC Voltage and Current Requirements +5V ±5% (Operating), 8% (start-up) Physical Height 0.5" (12.7mm) Width 5.04" (128mm) Depth 5.07" (129mm) Weight 7.05oz (200g) Connectors IDE Interface Connector 50 Pin I/F ATAPI Standard Regulatory The SD-C2612 DVD Writeable drive has been cert...
Page 12 - Drive Connectors –SD-C2612; Figure 1.SD-C2612 DVD Writeable Drive Rear Panel – Connector; PIN
10 Drive Connectors –SD-C2612 Figure 1.SD-C2612 DVD Writeable Drive Rear Panel – Connector ATAPI Connector A 50-pin ATAPI interface connector is found at the rear of the SD-C2612 DVD-ROM drive. Connecting cable should use Japan Aviation Electronics Industry Limited KX14-50Series L or equivalent conn...