Toshiba 37AV500A - Manuals - manualsarea.com

Page 2 - Contents; Introduction; Other Digital TV features and settings; Connecting your TV; Reference section

2 Contents Introduction Welcome to Toshiba ...........................................................3Important Safety Instructions .............................................3 Installation ....................................................................3Use .....................................

Page 3 - Installation

3 Welcome to Toshiba Thank you for purchasing this Toshiba LCD Color television. This manual will help you use the exciting features of your new TV.Instructions in this manual are based on using the remote control.Please read all safety and operating instructions in this manual carefully, and keep t...

Page 4 - 0) Precautions for installing on outdoor antenna; Use; ) Never place hot objects or open flame sources,; ) The apparatus shall not be exposed to dripping or

4 Introduction 8) Always place the TV on the floor or a sturdy, level, stable surface that can support the weight of the unit. To secure the TV, use a sturdy strap from the hooks on the rear of the TV to a wall stud, pillar, or other immovable structure. Make sure the strap is tight, secure, and par...

Page 5 - Service

5 Introduction 5) When the TV will not be used for a long period of time, such as during vacation or travel, remove the power plug from the wall outlet for safety. The TV is not completely disconnected from the power supply line, as minute current is consumed even when the Power switch is turned off...

Page 6 - Cleaning; Important information; Exemptions

6 Introduction Cleaning 1) Remove the power plug before cleaning. Never use solvents such as benzine or thinner to clean the TV. These solvents may distort the cabinet or damage its finish. If rubber or vinyl products remain in contact with the TV for a long time, a stain may result. If the cabinet ...

Page 7 - Connecting an antenna; Exploring your new TV; Installing the remote control batteries; Effective range; Getting started

7 Connecting an antenna Optimum reception of color requires a good signal and will generally mean that an outdoor antenna must be used. The exact type and positioning of the antenna will depend upon your particular area. Your Toshiba dealer or service personnel can best advise you on which antenna t...

Page 8 - OK; TV front, control and side panel; MENU

8 Getting started (Input source selection) — When no menu is on- screen, this button selects the input source ( page 23). OK — When a TV menu is on-screen, this button functions as the next menu navigation button( page 11). (Arrows) — When a TV menu is on-screen, these buttons function as up/down/le...

Page 9 - TV back panel connections; — For use when; — For service use only.

9 Getting started TV back panel connections HDMI1,2 (input terminals) — High-Definition Multimedia Interface input receives digital audio and uncompressed digital video from an HDMI device or uncompressed digital video from a DVI device ( page 29). PC/HDMI1 (AUDIO) (input terminals) — For use when c...

Page 10 - Learning about the remote control; Location of controls

10 Getting started Learning about the remote control Location of controls To switch between Analog and Digital TV ( page 11) To return to the previous program ( page 16) To display digital on-screen information ( page 26) MENU ( . page 11) • Menu ! ( page 11) • OK ( pages 11) Program position ( page...

Page 11 - Learning about the menu system; DTV; TV SETUP menu chart; About DTV Menu

11 Getting started This integrated TV is equipped with both Digital and Analog system. To switch between Digital and Analog TV press A/D on the remote control. Learning about the menu system We suggest you familiarize yourself with the display charts before using the menu system: Press to display me...

Page 12 - About ATV Menu; Turning the TV on; Switching on the TV

12 Getting started About ATV Menu Notes for menu system: In the video input mode ( Video1 , Video2, HDMI, PC ), Auto tuning / Full Search and Manual Adjust / Manual Search are not available. ( page 26). If you do not make a selection for a while, the menu display disappears automatically.If you want...

Page 13 - Tuning the TV for the first time

13 Getting started Tuning the TV for the first time Before switching on the TV, put your decoder and media recorder to Standby if they are connected and ensure the antenna is connected. To setup the TV use the buttons on the remote control as detailed on page 10. This screen will appear the first ti...

Page 14 - Auto Tuning

14 Getting started Manual Search - digital only - If there were any missing channel after Full Search , these channels might be found by using Manual Search described in this section. From the Setup menu, press V or U to select Manual Search . Press , then press Y or Z to select the channel(0~69) yo...

Page 15 - Sorting program position

15 Getting started Manual Adjust - analog only - Use the Manual Adjust operation if desired channels cannot be preset with the Auto tuning or if you would like to presetchannels to specific position numbers one by one. From the SET UP menu, press V or U to select Manual Adjust . ATV Menu...[Setup......

Page 16 - Favorite Channel

16 Getting started From the SET UP menu, Press and V or U to select Channel List . DTV Menu...[Setup...Channel List] L a nguage Country/Region Full Search Quick Search Channel List Manual Search Fav Group : 1 EXIT OK MENU Confirm Return Navigate Cancel Press to display the Channel List menu. Press V...

Page 17 - Watching TV programs; Viewing Digital programs; Displaying the on-screen information

17 Getting started Watching TV programs Viewing Digital programs - digital only - After you have tuned the TV, you have several ways tonavigate through all programs: Press the Number buttons (a channel number has 3-digits) and you may omit the leading zeroes, which will be appended automatically; (P...

Page 18 - Picture adjustment; Selecting the picture size

18 Picture adjustment Selecting the picture size Each time you press , picture size information will change again. The information will disappear in variable time, which is dependent on banner duration setting. WIDE Picture size will change as below mode: Wide, Super Live 2, Cinema 2,4:3, Super Live...

Page 19 - Automatically Adjusting the picture position; Mode; Adjusting the basic picture quality; Selection

19 Using the TV’s features (General) Notes: Using the special functions to change the size of the displayed image (e.g. changing the height/width ratio) for the purpose of public display or commercial gain may infringe on copyright laws.If the aspect ratio of the selected format is different from th...

Page 20 - Using the cinema mode; Effective signal and setup conditions:; Selecting the color temperature; Using the active backlight control

20 Using the TV’s features (General) If you want to adjust Backlight manually, turn Active Backlight Control to Off , then press V . Press Y or Z to adjust the settings as required. 1 0 Using the cinema mode A movie film’s picture runs at 24 frames a second, whereas movie software such as DVD, etc.,...

Page 21 - Sound adjustment; Auto mode; Mono mode; Selecting the dual 1 or dual 2 mode; Selecting the stereo programs; Adjusting the sound quality

21 Using the TV’s features (General) Sound adjustment Setting the MTS (Multi-channel TV Sound) - analog only - Auto mode The MTS Auto mode automatically recognize stereo/bilingual programs depending on the broadcast signal. Press , then press Y or Z to display the SOUND menu then press . Press V or ...

Page 22 - Setting the Sleep Timer; Timer; Setting the Power Control; Power Control; Using the Bass Boost; The timers; Setting the Current Time

22 Using the TV’s features (General) Press Z into the Timer data position and press V and U to set the time period. Press to exit Menu. Press on the remote control or control panel. Setting the Sleep Timer The Sleep Timer is especially useful if you want the TV to turn itself off after a selected pe...

Page 23 - Setting the Banner Duration; Teletext in Analog TV; Setting up the teletext mode; To select teletext mode:; Teletext general information; each color

23 Using the TV’s features (General) Setting the Banner Duration - digital / analog - Press , then Y or Z to display the TIMER menu, then press . Press V or U to select Banner Duration , then press . Press Y or Z to set Banner Duration which can be set 1 to 12 seconds. Notes: Banner Duration functio...

Page 24 - Teletext buttons on the remote control; In Auto mode; Using Auto mode; Auto; Using LIST mode

24 Using the TV’s features (General) Press to store your choice. The bars at the bottom of the screen will flash white. You may view other pages by simply entering the 3-digit page number – but NEVER press or you will lose the favorite already stored. Teletext buttons on the remote control Below is ...

Page 26 - Setting the Password; Parental Rating; Setting the Parental Rating

26 Setting the EPG (Electronic Program guide) - digital only - Press then Y or Z to select Function menu. Press and V or U to select EPG then, press to display EPG . DTV Menu...[FUNCTION...EPG] AV Connection Parental Rating Channel Lock Password Reset to default EXIT OK MENU Confirm Return Navigate ...

Page 27 - Subtitle; Audio Preference; Selecting The Audio Mode; Digital Output Format

27 Other Digital TV features and settings AV Connection Press , then press Y or Z to select the FUNCTION menu. Press and press V or U to select AV Connection , then press . DTV Menu...[FUNCTION... AV Connection ] Video 1 Video 2 EXIT OK MENU Confirm Return Navigate Cancel AV Connection Parental Rati...

Page 28 - Back connections; Connection example; COMPONENT VIDEO INPUT; consists of three; MONITOR OUTPUT; , connect the audio input of the equipment to the; Connecting an audio system; Bitstream; in Digital Output menu.

28 Back connections Connection example TV back view DVD video player (with component video outputs) Set Top Box VCR (Recording) or HDMI or DVI device or Before connecting any external equipment, turn off all main power switches.The unauthorized recording of television programs, DVDs, video tapes and...

Page 29 - in; Side connections; Connecting an HDMI or a DVI device; Connecting an; : Digital Video Interface

29 Connecting your TV Connecting an amplifier equipped with an MPEG decoder TO Digital Audio output terminal To Optical or Coaxial type digital audio input Optical or Coaxial digital cable (not supplied) Ampliﬁer equipped with MPEG decoder TV back view Front speaker Surround speaker Sub woofer Cente...

Page 30 - Standard analog audio cables; Connecting a computer; Connect a PC cable from the computer to the; The following signals can be displayed:; Therefore, the TV may not display small text properly.; Connecting an HDMI device; Connecting a DVI device

30 Connecting your TV HDMI (type A connector)-to-DVI adapter cable For proper operation, the length of an HDMI-to-DVI adapter cable should not exceed 3m. The recommended length is 2m. Standard analog audio cables An HDMI-to-DVI adapter cable transfers only video.Separate analog audio cables are requ...

Page 31 - Signal names for mini D-sub 15 pin connector; Using the PC setting; PC of the Auto Adjust; PICTURE; Auto adjust

31 Connecting your TV There is no need to use an adapter for computers with DOS/ V compatible mini D-sub 15 pin terminal.A bar may appear in the upper, lower, right or left side of the screen, or parts of the picture may be obscured depending on some signals. This is not the malfunction.If the edges...

Page 32 - Troubleshooting; Symptom and solution

32 Troubleshooting Before calling a service technician, please check the following table for a possible cause of the symptom and some solutions. Symptom and solution TV will not turn on Make sure the power cord is plugged in, then press or . The remote control batteries may be dead. Replace the batt...

Page 33 - APPENDIX; AUSTRALIAN PARENTAL GUIDANCE CODES (Normative)

33 Reference section APPENDIX AUSTRALIAN PARENTAL GUIDANCE CODES (Normative) Recommended On-Screen-Display for parental guidance codes transmitted within DVB-SI EIT information using the DVBparental_rating_descriptor. Receiver Menu Set-up and Suggested OSD wording for Setting Blocking (Restriction o...

Page 34 - Broadcast system; Oceania; Specifications; Integrated Digital LCD TV

34 Reference section Analog TV system (Antenna input) Channel coverage: PAL B/G (CCIR) VHF UHFCATV 0 - 12 27 - 69 C2, C10, C31, S2 - S44 Digital TV System Compliant Standard DVB-TVideo Decoding MP @ ML & MP @ HLAudio Decoding Dolby® Digital, MPEG (I & II)Audio Sampling Rate 32, 44.1, 48 kHz ...

Page 35 - Operating condition

35 Reference section Input/Output terminals (1) InputRCA Component Video RCA Composite Video Audio : RCA Y, PB/CB, PR/CR CVBSL/Mono+R(shared between Component and Composite) (2) InputRCA/Mini-Din(4 pin)Composite Video(CVBS) +S-videoAudio : RCA L/Mono+R (shared between S-Video and Composite) MONITOR ...

Page 36 - Note