Toro 88613 - Manuals

Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any areaof potential danger. Replace any decal that is damaged or missing. decal140-8460 140-8460 1. Cutting hazard of hand. 7. Do no expose to rain. 2. Stay away from moving parts....

Setup Filling the Chain Saw withBar and Chain Oil Important: Use only bar and chain oil (sold separately). Fill the chain saw with bar and chain oil; refer to Checking the Oil Level and Adding Bar and ChainOil (page 17) . Product Overview g315699 Figure 4 Left side shown 1. Chain 6. Battery pack 2. ...

Specifications Model 51845T Bar Length (with 88613 and88614 equipped) 40.6 cm (16 inches) Chain Gauge (with 88613and 88614 equipped) 0.043 inches Chain Pitch (with 88613 and88614 equipped) 3/8 inch Chain Length (with 88613and 88614 equipped) 56 links Rated Voltage 60V DC maximum, 54 VDCnominal usage...

Starting the Chain Saw 1. Ensure that the vents on the chain saw are freefrom dust and debris ( Figure 6 ). g315701 Figure 6 1. Side vent 2. Bottom vent 2. Set the chain saw down on a level surface. 3. Align the tongue of the battery pack with thebattery cavity in the chain saw ( Figure 7 ). g315702...

Cutting with the Chain Saw WARNING Operating a chain saw improperly can causeserious personal injury or death. Read and follow all operating instructionscarefully to avoid possible personal injury. WARNING Kickback can cause serious or fatal injury toyou. Always ensure that the chain brake systemis ...

Pruning a Tree WARNING Cutting higher limbs from a tree off the groundcan put you in an unstable position that couldbe unsafe for you while handling a chain saw,resulting in possible serious personal injuryor death to you or bystanders. When cutting limbs from a standing tree, usethe following pract...

Limbing a Fallen Tree 1. Grip the chain saw as shown in Figure 11 . 2. Moving from the base of the tree up, cut off the smaller limbs from the tree that are not supporting itsweight off the ground ( Figure 17 ). 3. Cut the larger limbs that support the weight of the tree from the bottom upward so th...

Bucking a Log When bucking a log, note where the log is supportedand where there is a load on the log. Cut the log sothat when the ends fall, your guide bar will not bepinched between them. Important: If the chain saw binds in the cut, do not attempt to free it by running the motor. Shutoff the saw,...

Installing the Battery Pack 1. Set the chain saw down on a level surface. 2. Align the tongue of the battery pack with thebattery cavity in the chain saw ( Figure 22 ). g315702 Figure 22 3. Push the battery pack into the battery cavity untilthe battery pack locks into place. Removing the Battery Pac...

Maintenance Recommended Maintenance Schedule(s) Maintenance Service Interval Maintenance Procedure Before each use or daily • Check the oil level and add bar and chain oil if necessary.• Check the chain brake.• Check that oil is flowing to the chain.• Check the chain tension and adjust it if necessa...

Checking the Chain Brake Service Interval: Before each use or daily After each battery drain cycle 1. Place the chain saw on a flat surface andremove the battery pack; refer to Removing the Battery Pack (page 16) . 2. Engage the chain brake by moving the chainbrake forward to the STOP position ( Fig...

Adjusting the ChainTension Service Interval: Before each use or daily After each battery drain cycle Ensure that the chain is properly tensioned. A loose chain shortens the life of the drive sprocketand the guide bar and may cause the chain to fall off. An overtightened chain overheats the guide bar...

Installing the Guide Bar andChain DANGER Contact with the chain saw teeth can causeserious personal injury. • Remove the battery pack before adjustingor maintaining the chain saw. • Always wear gloves when adjusting ormaintaining the chain saw. 1. If the side cover is installed to the machine,loosen...

Storage Important: Store the machine, battery pack, and charger only in temperatures that are within theappropriate range; refer to Specifications (page 9) . Important: If you are storing the battery pack for the off-season, charge it until 2 or 3 LEDindicators turn green on the battery. Do not stor...

Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair workmust be performed by an authorized service center or a similarly qualified specialist if you cannot solve theproblem yourself. Problem Possible Cause Corrective Action 1. The b...