Toro 79410 - Manuals

Toro 79410 – User Manual, Manual in PDF format online.

Manuals:

User Manual
Manual

User Manual Toro 79410

Summary

Page 2 - WARNING; Introduction; Contents

WARNING CALIFORNIA Proposition 65 Warning Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Introduction Read this information carefully to learn how to operateand maintain your product properly and to avo...

Page 3 - Safety; Towing Safety

Safety • Become familiar with the safe operation of theequipment, with the operator controls, and safetysigns. • Use extra care with grass catchers or otherattachments. These can change the operatingcharacteristics and the stability of the machine. • Follow the manufacturer's recommendationsfor addi...

Page 4 - Safety and Instructional Decals

Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any areaof potential danger. Replace any decal that is damaged or lost. decal109-6809 109-6809 1. Crushing hazard of hand—do not remove the whole bagger from the machine; open the b...

Page 5 - Setup; Loose Parts; Preparing the Machine; Procedure

Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Use 1 No parts required – Prepare the machine. Bolt (3/8 x 1 inch) 4 Locknut (3/8 inch) 6 Left weight-mounting bracket 1 Right weight-mounting bracket 1 Washer 2 Bolt (5/8 x 2-3/4 inches) 2 2...

Page 6 - Installing the Weights; CAUTION

2 Installing the Weights Parts needed for this procedure: 4 Bolt (3/8 x 1 inch) 6 Locknut (3/8 inch) 1 Left weight-mounting bracket 1 Right weight-mounting bracket 2 Washer 2 Bolt (5/8 x 2-3/4 inches) 6 Suitcase weight Procedure CAUTION The bagger changes the weight distribution ofthe machine. Opera...

Page 8 - Installing the Latch Rod; Assembling the Bagger Top

g300207 Figure 8 5. Insert the bent ends of the rods into theattachment mount as shown in Figure 8 and secure the end of each rod with a washer andhairpin cotter. 4 Installing the Latch Rod Parts needed for this procedure: 1 Latch rod 1 Hairpin cotter Procedure Install the latch rod with a hairpin c...

Page 9 - Installing the Bagger Top

g005666 Figure 10 1. Bagger top 3. Screen tab 2. Screen 4. Slot in bagger top 6 Installing the Bagger Top Parts needed for this procedure: 2 Grass Bag 1 Upper bagger tube 2 Pivot bracket 4 Bolt (5/16 x 1 inch) 4 Nut (5/16 inch) Procedure 1. Install the bagger top to the bagger frame. 2. Install the ...

Page 10 - Installing the Chute

g300378 Figure 12 5. Lower the bagger top onto the bags ( Figure 13 ). g033030 Figure 13 6. Install the upper bagger tube by inserting thecurved end into the opening in the bagger top. Note: Ensure that the flared end with the retention post is pointing down and froward inpreparation to be mated wit...

Page 12 - Operation; for the mower before using this

8 Connecting with theDischarge Tube Parts needed for this procedure: 1 Discharge tube Procedure 1. Slide the curved end of the discharge tube intothe opening in the bagger top ( Figure 18 ). g010641 Figure 18 1. Discharge tube 4. Peg 2. Opening in bagger top 5. Rubber strap 3. Discharge tube (flared...

Page 13 - Emptying the Grass Bags; Allow the machine to cool before storing it.

Emptying the Grass Bags WARNING Debris, such as leaves, grass, or brush cancatch fire. A fire in the engine area can causepersonal injury and property damage. • Keep the engine and muffler area free ofdebris accumulation. • Take care when opening the bagger coverto keep debris from falling onto the ...

Page 14 - Removing the Bagger

Clearing Obstructions fromthe Bagger WARNING When the bagger is in operation, the bloweris rotating and can cut off or injure hands andfingers. • Before adjusting, cleaning, repairingand inspecting the blower, and beforeunclogging the chute, shut off the engineand wait for all moving parts to stop.R...

Page 15 - Using the Draw Bar

Using the Draw Bar The bagger support bracket has a draw bar featurethat can be used for towing. • Read and understand all the operating instructionsof the machine. • When turning, slow down and observe theclearance. • Make wide turns and keep towed equipment clearof the towing vehicle. • Excessive ...

Page 16 - Operating Tips

Operating Tips Tips for Bagging Remembering the Size Remember that the machine is longer and wider withthis attachment installed. By turning too sharply inconfined places you may damage the attachment. Trimming Always trim with the left side of the mower. Do not trimwith the right side of the mower ...

Page 17 - Maintenance; Allow engines, especially the muffler, to cool before touching.; Keep the engine and muffler area free of debris accumulation.; Do not wash the grass bags.

Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Interval Maintenance Procedure After the first 10 hours • Inspect the bagger Before each use or daily • Clean the bagger Before storage • In...

Page 18 - Caring for the Grass Bags; Storage

Inspecting the MowerBlades Inspect the mower blades regularly and whenever ablade strikes a foreign object. If the blades are badly worn or damaged, install newblades. Refer to your mower or mower Operator's Manual for complete blade maintenance. Caring for the Grass Bags Do not wash the grass bags....

Page 20 - California Proposition 65 Warning Information

California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in C...