Toro 53887 - Manuals - manualsarea.com

Page 2 - Table of Contents

ii ii Table of Contents Parts Identification ................................................................................................................ 1 Battery Installation ................................................................................................................ 2 Atta...

Page 3 - Parts Identification

1 1 1 2 2 3 3 5 5 4 4 Parts Identification Congratulations on purchasing a Toro ® Single Station Timer (SST). You have a powerful but easy to use battery-operated valve controller that fits most common valves*. The SST comes with a DC-Latching solenoid attached, making connecting to your valve simpl...

Page 4 - Battery Installation; Unscrew all screws and remove the battery; The battery should be replaced as part of

2 Battery Installation Battery installation should take place before attaching the SST to a valve. If you have already attached the SST to a valve, you will need to detach it.1. Place the SST face down. The battery compartment is sealed with four (4) screws. 2. Unscrew all screws and remove the batt...

Page 5 - Attaching the SST to a Valve; Screw in the included adapter

3 * The included DC-latching solenoid is not compatible with Hunter® brand valves. Use of the SST with Hunter valves requires a Hunter DC-latching solenoid (sold separately).Hunter is a trademark of Hunter Industries. Attaching the SST to a Valve The SST includes a pre-wired DC-latching solenoid*. T...

Page 6 - LCD Overview; or rain sensor delay is active (flashing); AM

4 LCD Overview 1. Low battery indicator. If the icon is flashing, the battery is low and should be changed. If the icon is solid, the controller will not operate. Replace the battery. 2. Set current time indicator3. Digital display. Shows the current time or run-time during programming. 4. Day of we...

Page 7 - Programming the SST

5 Programming the SST Every programming operation begins by pressing the MODE button. A long press (>2 seconds) turns the controller off. A short press (<2 seconds) advances the controller through the different programming functions in the order that follows.Programming the Controller during a...

Page 10 - Set Watering Days

8 Press or to cycle to the correct start time hour. Press to set. 4. The minute number ( 00:00 ) will flash. Press or to advance to the correct start time minute. Press to set. 5. If in AM/PM mode, press or to select AM or PM. Press to set. 6. Repeat steps 2 through 5 to set additional start times, ...

Page 11 - Off Mode; again to cancel the OFF mode and return to active watering.; Sleep Mode

9 day, irrigation will run past midnight. Off Mode OFF mode turns off the watering program. Active Day boxes disappear. The time display and “OFF” toggle back and forth on the display. The current day flashes.1. Press for >2 seconds to activate OFF mode. 2. Press again to cancel the OFF mode and ...

Page 13 - Installing a Rain Sensor; wires. Connect the SST wires to the rain

11 Installing a Rain Sensor It is possible to connect a wired Toro® RainSensor™ to the SST. Other normally closed sensors can be installed as well. Wired polarity is not observed for the sensor. 1. Cut the wire loop (yellow) from the SST. (See Figure 1.) 2. Strip 1/2˝ (1.25 cm) of insulation from th...

Page 14 - The Reset Button; The Reset button resets the controller to erase all

12 The Reset Button The Reset button resets the controller to erase all watering programs.1. Remove the battery compartment lid and battery. 2. In the upper left corner, you will see a black button with a refresh symbol. Using a screwdriver, press that button. 3. Reinstall the battery.4. Reattach th...

Page 15 - Troubleshooting Guide; Problem

13 Troubleshooting Guide Problem Possible Cause Solution Controller does not display anything. 1. The battery is dead.2. Controller is in Sleep mode. 1. Install a new 9V battery.2. Press MODE to activate screen. Water does not turn ON. 1. Faulty control valve wire connections. 2. Faulty solenoid.3. ...

Page 16 - Warranty Statement

14 The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrants, to the owner, against defects in material and workmanship for a period of two years from the date of purchase. Neither The Toro Company nor Toro Warranty Company is liable for failu...