Toro 100 - Manuals

Toro 100 – Manual in PDF format online.

Manuals:

Manual

Manual Toro 100

Summary

Page 2 - Earth Ground Installation; Step 1 –; ) solid copper wire near the top of the; Step 3 –; ) solid copper wire and test again. If the; Figure 2

Earth Ground Installation IMPORTANT! The TDC surge protection components cannot properly function unless an efficient pathway to earth ground is provided. The ground path must be as direct as possible, without sharp bends and must not exceed 30 Ohm resistance (when measured with an earth ground resi...

Page 3 - Power Source Installation; for the appropriate type of; Figure 3

Power Source Installation Step 1 – Turn off the power at the power source location andplace the controller’s power switch to OFF. Connect androute the appropriate size 3-conductor cable (10 AWG[2.5mm 2 ] maximum) from the power source to the controller cabinet. The provided power cable access hole c...

Page 4 - Station Decoder Installation; make and model is the Paige Irrigation Wire, Spec P7351D.

Station Decoder Installation The station decoder module is available in 1-station, 2-station or 4-station configuration. The decoder modules are installed intothe TDC output board terminals. The stand-alone TDC model can handle up to 100 stations per output board. These stations can be connected to ...