Thermador CGB48FSZLP - Manuals

Page 2 - Contents; Locating your Char Glo

Contents SECTION 1: Safety Information ................................................................. 1 SECTION 2: Gas Requirements ............................................................ 2 – 3 Natural Gas Requirements ............................................................................

Page 3 - Shut off gas to the appliance.; FOR YOUR SAFETY; S’il y a une odeur de gaz:; AVERTISSEMENT

TESTED IN ACCORDANCE WITH ANSI Z21.58 – 1995, ANSI Z21.58a – 1998STANDARD FOR OUTDOOR COOKING GAS APPLIANCES, AND CAN/CGA 1.6-M95,CAN/CGA 1.6a-M98 STANDARD FOR OUTDOOR COOKING GAS APPLIANCES. This unit is for outdoor use only in a well-ventilated area. Not to beused in a building, garage or any othe...

Page 4 - The total gas consumption of the Thermador Char Glo; SECTION 2: GAS REQUIREMENTS; Tank Gas Regulator; Figure 1

NATURAL GAS REQUIREMENTS - Inlet Connection: 1/2" NP with 3/8" NPT reducer adapter. Supply Pressure: 6" to 14" W.C. Manifold Pressure: 4" W.C. GAS CONSUMPTION The total gas consumption of the Thermador Char Glo ® barbecues with all burners on "HI" is as follows: CGB30RFZL...

Page 5 - SECTION 2: GAS REQUIREMENTS; l’appareil ne doit pas exéceder 26.1 mm HG.

CAUTION: The appliance must be isolated from the gas supply system by closing itsindividual manual shut-off valve during any pressure testing of the gas supplypiping system at test pressures equal to or less than 1/2" psig (3.5kPa). When checking the manifold gas pressure, the inlet pressure to ...

Page 6 - The Thermador Char Glo; CAUTION; SECTION 3: ELECTRICAL REQUIREMENTS; WARNING; Electrical Grounding Instructions; Three-Prong Plug and Receptacle; Instruction pour la mise a la terre electrique; Figure 2

Page 4 Installation of electrical supply circuit should be done by a qualified electrician in accordance with localcodes and ordinances. In the absence of local codes or ordinances, the supply should be installed inaccordance with the National Electric Code ANSI/NFPA No. 70, current issue, or Canadi...

Page 7 - Liquid Propane Conversion to Natural Gas; Orifice Description

SECTION 4: UNPACKING, MOVING AND PLACING THE UNIT Leaving the unit on the pallet, move the unit close to the final installation site. Unpack and remove all accessory items, packingmaterials and product literature from inside the unit. Verify the gas supply type. If the unit is not compatible with th...

Page 8 - All Models are equipped with a Tank Gas; SECTION 4: UNPACKING, MOVING AND PLACING THE UNIT; turns to set proper low flow rate. See Figures 4 and 5.; FIGURE 6; LP Gas Tank; FIGURE 6A

10. All Models are equipped with a Tank Gas Pressure Regulator that is mounted on the LPtank connector. The regulator is set for LP.See Figure 6, below. SECTION 4: UNPACKING, MOVING AND PLACING THE UNIT 9. On all models, the bypass jet must be turned counterclockwise with a small flat-bladed screwdr...

Page 9 - GAS AND ELECTRICAL HOOK-UP; A regulator can also be purchased locally; To combustible construction -

GAS AND ELECTRICAL HOOK-UP With the unit located by the gas stubout, connectthe gas supply hose to the manual shut-off valve andopen valve. Check the connection points at theshut-off valve for any leaks and repair prior tooperating the unit. Connect the power supply cordto the electrical supply outl...

Page 11 - NOTES

Thermador CGB48FSZLP - Manuals

Manuals:

Manual Thermador CGB48FSZLP

Summary

Thermador Manuals