Thermador 9000039271 - Manuals

5 WARNING: ELECTRICAL SHOCK HAZARD - Working on an energized circuitcould result in serious injury or death. Onlyqualified electricians should perform electri-cal work. Do not attempt any work on thedishwasher electric supply circuit until youare certain the circuit is de-energized. WARNING: FIRE HA...

6 WARNING: SCALD HAZARD - Serious injury could result if work isperformed on a charged hot water line.Only qualified plumbers should performplumbing work. Do not attempt any workon the dishwasher hot water supply plumb-ing until you are certain the hot watersupply is shut off.CAUTION: Temperatures r...

8 Removing the Toe PanelDWHD94BF Regular Toe Panel The toe panel is loosely attached with tape. Removethe tape and pull the toe panel away from thedishwasher. Set the toe panel aside. It will bereinstalled later. DWHD94BP and DWHD94BS Base and ToePanel The base and toe panel are in place on thedishw...

9 DWHD94BF - Panel Installation DWHD94BF models come with additional mountinghardware and a template sheet that will show youhow to mount the panel. One side of the templateshows how to mount a one piece panel; the otherside shows how to mount a two piece panel. Decidewhich type of installation you ...

10 1. Straighten and position the hot water supply line and the electrical supply cable as shown in Figure16 so that they will align with their channels underthe dishwasher base. 2. Position the dishwasher close enough to the enclosure so that you can run the dishwasherdrain hose to the under sink d...

11 The dishwasher drain hose may be connected to thedrain plumbing in one of four ways: 1. Directly to the undersink dishwasher drain connection, as shown in Figure 20. 2. Directly to a disposer dishwasher drain connec- tion, as shown in Figure 21. 3. To the undersink dishwasher drain connection thr...

12 WARNING: SCALD HAZARD - Working on a charged hot water line could result inserious injury or death. Do not attempt anywork on the dishwasher hot water supplyplumbing until you are certain the hot watersupply is shut off. NOTE: Make certain that the correct 90° elbow fitting (not supplied) for the...

13 WARNING: ELECTRICAL SHOCK HAZARD - Working on an energized circuitcould result in serious injury or death. Onlyqualified electriciansshould perform electrical work. Do notattempt any work on the dishwasher electricsupply circuit until you are certain the circuitis de-energized. WARNING: FIRE HAZA...

14 WARNING: FIRE HAZARD - loose or improper electrical connections can causefire. Make certain that all electricalconnections are properly made. • Do not pre-twist the wires before connecting them with wire nuts. • Extend the dishwasher’s stranded wires 1/8” (3mm) beyond the power supply cable’s sol...

15 DWHD94BP and DWHD94BS Base and Toe PanelInstallation 1. Place the Base Part under and up the front bottom panel of the dishwasher, as shown in Figure 29. 2. Insert the Base Part screws (Figure 1, letter O) into the Base Part, as shown in Figure 29, letter B.Tighten the Base Part Screws. 3. Place ...

16 Please be sure to include (if you are writing), or have available (if you are calling), the following information: • Model number • Serial number • Date of original purchase • Date the problem originated • Explanation of the problem Also, if you are writing, please include a daytime phone number ...