Telex N/DYM SERIES - Manuals

Page 2 - ENGLISH; Receiver Setup; Transmitter Setup; gain adjust; Quick System Setup Guide

ENGLISH 1. Quick System setup guide 2. System Description 3. Detailed system/component setup instructions 3.1 Receiver Setup & Operation 3.2 Handheld Transmitter Setup 3.3 Beltpack Setup 4. Guidelines/Recommendations for best performance 5. Troubleshooting Guide 6. Technical Specifications 7. Ce...

Page 3 - System Description; System Features; Detailed Setup Instructions

ENGLISH 2. System Description The Electro-Voice N/DYM Wireless is a series of 10 channel frequency agile UHF wireless systems that combineEV’s legendary quality and reliability with high value. The N/DYM Series transmitters and receivers operate in theUHF frequency range on one of ten channels betwe...

Page 4 - set; Adjust the squelch control if necessary.

ENGLISH 5. Channel change lock-out. Once the channel has been set on the receiver, the N/DYM system hasthe capability to deactivate or lock-out the channel change button. This is done by depressing the set button for 10 seconds or more. Lock-out is active when the decimal point illumi-nates in the l...

Page 5 - Handheld Transmitter Setup; Set handheld transmitter channel

ENGLISH 3.2 Handheld Transmitter Setup 1. Insert battery. Slide open the hinged battery compartment cover by placing your thumb on theindents of the battery door (at the bottom of thetransmitter) and gently pushing down (see Figure3). Insert the battery, terminal end first, into thecompartment, with...

Page 6 - Bodypack Transmitter Setup

ENGLISH 3.3 Bodypack Transmitter Setup 1. Insert battery . Open the hinged battery compartment by placing your thumb or fingeron the indent labeled OPEN on the batterydoor and pushing down, see Figure 6. Wheninserting the battery, pay attention to the polari-ty (+/-) and insert the terminals into th...

Page 7 - Guidelines/Recommendations for best performance

ENGLISH Figure 6. 4 Guidelines/Recommendations for best performance Compatibility The receiver and transmitter must be set to the same channelto operate together. Using Multiple Wireless Systems If two or more N/DYM Wireless and/or other VHF/UHF wire-less systems are being used in the same location,...

Page 8 - Problem; Troubleshooting Guide

ENGLISH Problem Possible Causes Solutions No audio & no lights Receiver is off Make sure that power supply is on receiver properly connected and providing power to the receiver. No audio & no Tx ON Transmitter is off. Turn on transmitter power switch. light on receiver No ( or dead ) battery...

Page 9 - N/DYM Wireless Series System Technical Specifications

ENGLISH UHF Receivers: NRU and NRU-G Receivers Receiver Type Synthesized PLL Frequency Range (RF) Between 800 - 814 MHz Number of Selectable Channels 10 Diversity True Diversity with Secure-Phase TM RF Sensitivity < .8 uV for 12 dB SINAD FCC Data Approved under part 15 Audio Output, Frequency Res...

Page 10 - NRU; Description; Certifications

ENGLISH CERTIFICATIONS NRU , NRSCU , Certified to ETS 300 445, Conforms to European Union directives, eligible to bear CE marking. NHTU , NBPU , Certified to I-ETS 300 442 and ETS 300 445, Conforms to European Union directives, eligible to bear CE marking. Licensing of Electro-Voice equipment is the...

Page 11 - Factory Service; Exclusions and Limitations:; Electro-Voice Wireless Systems

ENGLISH ENGLISH Factory Service If factory service is required, ship the unit prepaid in its original carton to: Telex EVI Audio GmbHHirschberger Ring 45D-94315 StraubingTelephone: +49 (0) 9421 706 0Fax: +49 (0) 9421 706 350 Enclose a note describing the problem along with any other pertinent inform...

Page 12 - Service/Warranty – North America

ENGLISH Factory Service If factory service is required, ship the unit prepaid in its original carton to: EV Audio Servicec/o Telex Communications8601 E. Cornhusker HighwayTel: 402/467-5321Fax: 402/467-3279 Enclose a note describing the problem along with any other pertinent information. Warranty (Li...